fbdev: sh_mobile_hdmi: enable "external" mode

The SH-Mobile HDMI controller supports two configuration modes: using
pre-programmed VICs and the "external" mode - specifying video parameters
explicitly. The driver already contains code, necessary to configure HDMI
manually, this patch actually enables it.

Signed-off-by: Guennadi Liakhovetski <g.liakhovetski@gmx.de>
Signed-off-by: Paul Mundt <lethal@linux-sh.org>
diff --git a/drivers/video/sh_mobile_hdmi.c b/drivers/video/sh_mobile_hdmi.c
index 27d76bc..a8cf9a5 100644
--- a/drivers/video/sh_mobile_hdmi.c
+++ b/drivers/video/sh_mobile_hdmi.c
@@ -205,6 +205,7 @@
 struct sh_hdmi {
 	void __iomem *base;
 	enum hotplug_state hp_state;
+	bool preprogrammed_mode;	/* use a pre-programmed VIC or the external mode */
 	struct clk *hdmi_clk;
 	struct device *dev;
 	struct fb_info *info;
@@ -282,7 +283,10 @@
 
 	hdmi_write(hdmi, var->vsync_len, HDMI_EXTERNAL_V_DURATION);
 
-	/* Set bit 0 of HDMI_EXTERNAL_VIDEO_PARAM_SETTINGS here for manual mode */
+	/* Set bit 0 of HDMI_EXTERNAL_VIDEO_PARAM_SETTINGS here for external mode */
+	if (!hdmi->preprogrammed_mode)
+		hdmi_write(hdmi, sync | 1 | (voffset << 4),
+			   HDMI_EXTERNAL_VIDEO_PARAM_SETTINGS);
 }
 
 /**
@@ -633,6 +637,13 @@
 		 var->upper_margin, var->yres, var->lower_margin, var->vsync_len,
 		 PICOS2KHZ(var->pixclock));
 
+	if ((hdmi->var.xres == 720 && hdmi->var.yres == 480) ||
+	    (hdmi->var.xres == 1280 && hdmi->var.yres == 720) ||
+	    (hdmi->var.xres == 1920 && hdmi->var.yres == 1080))
+		hdmi->preprogrammed_mode = true;
+	else
+		hdmi->preprogrammed_mode = false;
+
 	hdmi_external_video_param(hdmi);
 }