V4L/DVB (6854): xc2028: be more specific about when applying offset for 7MHz channels
We have been inserting a mystery 500kHz offset for tuning 7MHz channels,
however some experimentation reveals it is only needed under certain
conditions with specific firmware combinations. Document these and only
apply the offset when we know it is required.
Signed-off-by: Chris Pascoe <c.pascoe@itee.uq.edu.au>
Signed-off-by: Mauro Carvalho Chehab <mchehab@infradead.org>
diff --git a/drivers/media/video/tuner-xc2028.c b/drivers/media/video/tuner-xc2028.c
index a6b05df..63a6fca 100644
--- a/drivers/media/video/tuner-xc2028.c
+++ b/drivers/media/video/tuner-xc2028.c
@@ -875,7 +875,16 @@
rc = send_seq(priv, {0x00, 0x00});
} else {
offset = 2750000;
- if (priv->cur_fw.type & DTV7)
+ /*
+ * We must adjust the offset by 500kHz in two cases in order
+ * to correctly center the IF output:
+ * 1) When the ZARLINK456 or DIBCOM52 tables were explicitly
+ * selected and a 7MHz channel is tuned;
+ * 2) When tuning a VHF channel with DTV78 firmware.
+ */
+ if (((priv->cur_fw.type & DTV7) &&
+ (priv->cur_fw.scode_table & (ZARLINK456 | DIBCOM52))) ||
+ ((priv->cur_fw.type & DTV78) && freq < 470000000))
offset -= 500000;
}