cpufreq: drivers: don't check range of target freq in .target()
Cpufreq core checks the range of target_freq before calling driver->target() and
so we don't need to do it again.
Remove it.
Signed-off-by: Viresh Kumar <viresh.kumar@linaro.org>
Acked-by: Linus Walleij <linus.walleij@linaro.org>
Signed-off-by: Rafael J. Wysocki <rafael.j.wysocki@intel.com>
diff --git a/arch/arm/mach-davinci/cpufreq.c b/arch/arm/mach-davinci/cpufreq.c
index 55eb870..8fb0c2a 100644
--- a/arch/arm/mach-davinci/cpufreq.c
+++ b/arch/arm/mach-davinci/cpufreq.c
@@ -79,15 +79,6 @@
struct davinci_cpufreq_config *pdata = cpufreq.dev->platform_data;
struct clk *armclk = cpufreq.armclk;
- /*
- * Ensure desired rate is within allowed range. Some govenors
- * (ondemand) will just pass target_freq=0 to get the minimum.
- */
- if (target_freq < policy->cpuinfo.min_freq)
- target_freq = policy->cpuinfo.min_freq;
- if (target_freq > policy->cpuinfo.max_freq)
- target_freq = policy->cpuinfo.max_freq;
-
freqs.old = davinci_getspeed(0);
freqs.new = clk_round_rate(armclk, target_freq * 1000) / 1000;
diff --git a/drivers/cpufreq/dbx500-cpufreq.c b/drivers/cpufreq/dbx500-cpufreq.c
index 7192a6d..15ed367 100644
--- a/drivers/cpufreq/dbx500-cpufreq.c
+++ b/drivers/cpufreq/dbx500-cpufreq.c
@@ -37,12 +37,6 @@
unsigned int idx;
int ret;
- /* scale the target frequency to one of the extremes supported */
- if (target_freq < policy->cpuinfo.min_freq)
- target_freq = policy->cpuinfo.min_freq;
- if (target_freq > policy->cpuinfo.max_freq)
- target_freq = policy->cpuinfo.max_freq;
-
/* Lookup the next frequency */
if (cpufreq_frequency_table_target(policy, freq_table, target_freq,
relation, &idx))