MXC: Remove WD IRQ priority setting
Remove WD IRQ priority setting from ARCH_MXC common init code, because
it's application specific.
Signed-off-by: Darius Augulis <augulis.darius@gmail.com>
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
diff --git a/arch/arm/plat-mxc/irq.c b/arch/arm/plat-mxc/irq.c
index a41abf0..da28105 100644
--- a/arch/arm/plat-mxc/irq.c
+++ b/arch/arm/plat-mxc/irq.c
@@ -116,11 +116,6 @@
for (i = 0; i < 8; i++)
__raw_writel(0, AVIC_NIPRIORITY(i));
- /* Set WDOG2's interrupt the highest priority level (bit 28-31) */
- reg = __raw_readl(AVIC_NIPRIORITY(6));
- reg |= (0xF << 28);
- __raw_writel(reg, AVIC_NIPRIORITY(6));
-
/* init architectures chained interrupt handler */
mxc_register_gpios();