e1000e: add support for 82583 device id
Add device ID and related support for 82583 mac.
Signed-off-by: Alexander Duyck <alexander.h.duyck@intel.com>
Acked-by: Radheka Godse <radheka.godse@intel.com>
Acked-by: Bruce Allan <bruce.w.allan@intel.com>
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/e1000e/82571.c b/drivers/net/e1000e/82571.c
index 51f8e84..6c01a207 100644
--- a/drivers/net/e1000e/82571.c
+++ b/drivers/net/e1000e/82571.c
@@ -40,6 +40,7 @@
* 82573E Gigabit Ethernet Controller (Copper)
* 82573L Gigabit Ethernet Controller
* 82574L Gigabit Network Connection
+ * 82583V Gigabit Network Connection
*/
#include <linux/netdevice.h>
@@ -100,6 +101,7 @@
phy->type = e1000_phy_m88;
break;
case e1000_82574:
+ case e1000_82583:
phy->type = e1000_phy_bm;
break;
default:
@@ -122,6 +124,7 @@
return -E1000_ERR_PHY;
break;
case e1000_82574:
+ case e1000_82583:
if (phy->id != BME1000_E_PHY_ID_R2)
return -E1000_ERR_PHY;
break;
@@ -165,6 +168,7 @@
switch (hw->mac.type) {
case e1000_82573:
case e1000_82574:
+ case e1000_82583:
if (((eecd >> 15) & 0x3) == 0x3) {
nvm->type = e1000_nvm_flash_hw;
nvm->word_size = 2048;
@@ -262,6 +266,7 @@
switch (hw->mac.type) {
case e1000_82574:
+ case e1000_82583:
func->check_mng_mode = e1000_check_mng_mode_82574;
func->led_on = e1000_led_on_82574;
break;
@@ -375,6 +380,7 @@
return e1000e_get_phy_id(hw);
break;
case e1000_82574:
+ case e1000_82583:
ret_val = e1e_rphy(hw, PHY_ID1, &phy_id);
if (ret_val)
return ret_val;
@@ -464,8 +470,15 @@
if (ret_val)
return ret_val;
- if (hw->mac.type != e1000_82573 && hw->mac.type != e1000_82574)
+ switch (hw->mac.type) {
+ case e1000_82573:
+ case e1000_82574:
+ case e1000_82583:
+ break;
+ default:
ret_val = e1000e_acquire_nvm(hw);
+ break;
+ }
if (ret_val)
e1000_put_hw_semaphore_82571(hw);
@@ -505,6 +518,7 @@
switch (hw->mac.type) {
case e1000_82573:
case e1000_82574:
+ case e1000_82583:
ret_val = e1000_write_nvm_eewr_82571(hw, offset, words, data);
break;
case e1000_82571:
@@ -779,7 +793,10 @@
* Must acquire the MDIO ownership before MAC reset.
* Ownership defaults to firmware after a reset.
*/
- if (hw->mac.type == e1000_82573 || hw->mac.type == e1000_82574) {
+ switch (hw->mac.type) {
+ case e1000_82573:
+ case e1000_82574:
+ case e1000_82583:
extcnf_ctrl = er32(EXTCNF_CTRL);
extcnf_ctrl |= E1000_EXTCNF_CTRL_MDIO_SW_OWNERSHIP;
@@ -795,6 +812,9 @@
msleep(2);
i++;
} while (i < MDIO_OWNERSHIP_TIMEOUT);
+ break;
+ default:
+ break;
}
ctrl = er32(CTRL);
@@ -820,8 +840,16 @@
* Need to wait for Phy configuration completion before accessing
* NVM and Phy.
*/
- if (hw->mac.type == e1000_82573 || hw->mac.type == e1000_82574)
+
+ switch (hw->mac.type) {
+ case e1000_82573:
+ case e1000_82574:
+ case e1000_82583:
msleep(25);
+ break;
+ default:
+ break;
+ }
/* Clear any pending interrupt events. */
ew32(IMC, 0xffffffff);
@@ -891,17 +919,22 @@
ew32(TXDCTL(0), reg_data);
/* ...for both queues. */
- if (mac->type != e1000_82573 && mac->type != e1000_82574) {
+ switch (mac->type) {
+ case e1000_82573:
+ case e1000_82574:
+ case e1000_82583:
+ e1000e_enable_tx_pkt_filtering(hw);
+ reg_data = er32(GCR);
+ reg_data |= E1000_GCR_L1_ACT_WITHOUT_L0S_RX;
+ ew32(GCR, reg_data);
+ break;
+ default:
reg_data = er32(TXDCTL(1));
reg_data = (reg_data & ~E1000_TXDCTL_WTHRESH) |
E1000_TXDCTL_FULL_TX_DESC_WB |
E1000_TXDCTL_COUNT_DESC;
ew32(TXDCTL(1), reg_data);
- } else {
- e1000e_enable_tx_pkt_filtering(hw);
- reg_data = er32(GCR);
- reg_data |= E1000_GCR_L1_ACT_WITHOUT_L0S_RX;
- ew32(GCR, reg_data);
+ break;
}
/*
@@ -966,18 +999,30 @@
}
/* Device Control */
- if (hw->mac.type == e1000_82573 || hw->mac.type == e1000_82574) {
+ switch (hw->mac.type) {
+ case e1000_82573:
+ case e1000_82574:
+ case e1000_82583:
reg = er32(CTRL);
reg &= ~(1 << 29);
ew32(CTRL, reg);
+ break;
+ default:
+ break;
}
/* Extended Device Control */
- if (hw->mac.type == e1000_82573 || hw->mac.type == e1000_82574) {
+ switch (hw->mac.type) {
+ case e1000_82573:
+ case e1000_82574:
+ case e1000_82583:
reg = er32(CTRL_EXT);
reg &= ~(1 << 23);
reg |= (1 << 22);
ew32(CTRL_EXT, reg);
+ break;
+ default:
+ break;
}
if (hw->mac.type == e1000_82571) {
@@ -999,7 +1044,9 @@
/* PCI-Ex Control Registers */
- if (hw->mac.type == e1000_82574) {
+ switch (hw->mac.type) {
+ case e1000_82574:
+ case e1000_82583:
reg = er32(GCR);
reg |= (1 << 22);
ew32(GCR, reg);
@@ -1007,6 +1054,9 @@
reg = er32(GCR2);
reg |= 1;
ew32(GCR2, reg);
+ break;
+ default:
+ break;
}
return;
@@ -1026,7 +1076,10 @@
u32 vfta_offset = 0;
u32 vfta_bit_in_reg = 0;
- if (hw->mac.type == e1000_82573 || hw->mac.type == e1000_82574) {
+ switch (hw->mac.type) {
+ case e1000_82573:
+ case e1000_82574:
+ case e1000_82583:
if (hw->mng_cookie.vlan_id != 0) {
/*
* The VFTA is a 4096b bit-field, each identifying
@@ -1041,6 +1094,9 @@
vfta_bit_in_reg = 1 << (hw->mng_cookie.vlan_id &
E1000_VFTA_ENTRY_BIT_SHIFT_MASK);
}
+ break;
+ default:
+ break;
}
for (offset = 0; offset < E1000_VLAN_FILTER_TBL_SIZE; offset++) {
/*
@@ -1139,9 +1195,16 @@
* the default flow control setting, so we explicitly
* set it to full.
*/
- if ((hw->mac.type == e1000_82573 || hw->mac.type == e1000_82574) &&
- hw->fc.requested_mode == e1000_fc_default)
- hw->fc.requested_mode = e1000_fc_full;
+ switch (hw->mac.type) {
+ case e1000_82573:
+ case e1000_82574:
+ case e1000_82583:
+ if (hw->fc.requested_mode == e1000_fc_default)
+ hw->fc.requested_mode = e1000_fc_full;
+ break;
+ default:
+ break;
+ }
return e1000e_setup_link(hw);
}
@@ -1362,11 +1425,19 @@
return ret_val;
}
- if ((hw->mac.type == e1000_82573 || hw->mac.type == e1000_82574) &&
- *data == ID_LED_RESERVED_F746)
- *data = ID_LED_DEFAULT_82573;
- else if (*data == ID_LED_RESERVED_0000 || *data == ID_LED_RESERVED_FFFF)
- *data = ID_LED_DEFAULT;
+ switch (hw->mac.type) {
+ case e1000_82573:
+ case e1000_82574:
+ case e1000_82583:
+ if (*data == ID_LED_RESERVED_F746)
+ *data = ID_LED_DEFAULT_82573;
+ break;
+ default:
+ if (*data == ID_LED_RESERVED_0000 ||
+ *data == ID_LED_RESERVED_FFFF)
+ *data = ID_LED_DEFAULT;
+ break;
+ }
return 0;
}
@@ -1659,3 +1730,19 @@
.nvm_ops = &e82571_nvm_ops,
};
+struct e1000_info e1000_82583_info = {
+ .mac = e1000_82583,
+ .flags = FLAG_HAS_HW_VLAN_FILTER
+ | FLAG_HAS_WOL
+ | FLAG_APME_IN_CTRL3
+ | FLAG_RX_CSUM_ENABLED
+ | FLAG_HAS_SMART_POWER_DOWN
+ | FLAG_HAS_AMT
+ | FLAG_HAS_CTRLEXT_ON_LOAD,
+ .pba = 20,
+ .get_variants = e1000_get_variants_82571,
+ .mac_ops = &e82571_mac_ops,
+ .phy_ops = &e82_phy_ops_bm,
+ .nvm_ops = &e82571_nvm_ops,
+};
+