Blackfin arch: Add new board support for ADZS-BF526-EZ-BRD
Signed-off-by: Michael Hennerich <michael.hennerich@analog.com>
Signed-off-by: Bryan Wu <cooloney@kernel.org>
diff --git a/arch/blackfin/Kconfig b/arch/blackfin/Kconfig
index 4154ff1..c507a92 100644
--- a/arch/blackfin/Kconfig
+++ b/arch/blackfin/Kconfig
@@ -249,7 +249,7 @@
config MEM_MT48LC32M16A2TG_75
bool
- depends on (BFIN527_EZKIT || BFIN532_IP0X || BLACKSTAMP)
+ depends on (BFIN527_EZKIT || BFIN532_IP0X || BLACKSTAMP || BFIN526_EZBRD)
default y
source "arch/blackfin/mach-bf527/Kconfig"
@@ -286,13 +286,20 @@
memory region is used to capture NULL pointer references as well
as some core kernel functions.
+config ROM_BASE
+ hex "Kernel ROM Base"
+ default "0x20040000"
+ range 0x20000000 0x20400000 if !(BF54x || BF561)
+ range 0x20000000 0x30000000 if (BF54x || BF561)
+ help
+
comment "Clock/PLL Setup"
config CLKIN_HZ
int "Frequency of the crystal on the board in Hz"
default "11059200" if BFIN533_STAMP
default "27000000" if BFIN533_EZKIT
- default "25000000" if (BFIN537_STAMP || BFIN527_EZKIT || H8606_HVSISTEMAS || BLACKSTAMP)
+ default "25000000" if (BFIN537_STAMP || BFIN527_EZKIT || H8606_HVSISTEMAS || BLACKSTAMP || BFIN526_EZBRD)
default "30000000" if BFIN561_EZKIT
default "24576000" if PNAV10
default "10000000" if BFIN532_IP0X
@@ -332,7 +339,7 @@
default "22" if BFIN533_BLUETECHNIX_CM
default "20" if (BFIN537_BLUETECHNIX_CM || BFIN527_BLUETECHNIX_CM || BFIN561_BLUETECHNIX_CM)
default "20" if BFIN561_EZKIT
- default "16" if (H8606_HVSISTEMAS || BLACKSTAMP)
+ default "16" if (H8606_HVSISTEMAS || BLACKSTAMP || BFIN526_EZBRD)
help
This controls the frequency of the on-chip PLL. This can be between 1 and 64.
PLL Frequency = (Crystal Frequency) * (this setting)