Bluetooth: btmrvl: don't send data to firmware while processing suspend
Usually when driver sends data to firmware it receives TX_DONE
(DN_LD_HOST_INT_STATUS) interrupt from firmware right away.
It's also observed that some times the fireware could delay
sending DN_LD_HOST_INT_STATUS interrupt. If driver sends data to
firmware during suspend processing and the TX_DONE interrupt is
delayed, it may come back at wrong time when SDIO host driver is
in the middle of suspending.
Block any data from stack while suspending. Also skip sending
data that are already in driver tx_queue.
Don't purge the skb queue on suspend to avoid intermittent music
after system resumes from S3.
Signed-off-by: Chin-Ran Lo <crlo@marvell.com>
Signed-off-by: Amitkumar Karwar <akarwar@marvell.com>
Signed-off-by: Marcel Holtmann <marcel@holtmann.org>
diff --git a/drivers/bluetooth/btmrvl_main.c b/drivers/bluetooth/btmrvl_main.c
index b2a567b..f25a825 100644
--- a/drivers/bluetooth/btmrvl_main.c
+++ b/drivers/bluetooth/btmrvl_main.c
@@ -436,6 +436,11 @@
BT_DBG("type=%d, len=%d", hci_skb_pkt_type(skb), skb->len);
+ if (priv->adapter->is_suspending || priv->adapter->is_suspended) {
+ BT_ERR("%s: Device is suspending or suspended", __func__);
+ return -EBUSY;
+ }
+
switch (hci_skb_pkt_type(skb)) {
case HCI_COMMAND_PKT:
hdev->stat.cmd_tx++;
@@ -452,7 +457,8 @@
skb_queue_tail(&priv->adapter->tx_queue, skb);
- wake_up_interruptible(&priv->main_thread.wait_q);
+ if (!priv->adapter->is_suspended)
+ wake_up_interruptible(&priv->main_thread.wait_q);
return 0;
}
@@ -643,7 +649,8 @@
if (adapter->ps_state == PS_SLEEP)
continue;
- if (!priv->btmrvl_dev.tx_dnld_rdy)
+ if (!priv->btmrvl_dev.tx_dnld_rdy ||
+ priv->adapter->is_suspended)
continue;
skb = skb_dequeue(&adapter->tx_queue);