spi_bfin: remove useless fault path
Remove useless return status check in restore_state function. Issue was
pointed out by Michael.
Cc: Michael Hennerich <michael.hennerich@analog.com>
Signed-off-by: Bryan Wu <bryan.wu@analog.com>
Signed-off-by: David Brownell <dbrownell@users.sourceforge.net>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
diff --git a/drivers/spi/spi_bfin5xx.c b/drivers/spi/spi_bfin5xx.c
index 61cc5e0..84c158a 100644
--- a/drivers/spi/spi_bfin5xx.c
+++ b/drivers/spi/spi_bfin5xx.c
@@ -223,10 +223,9 @@
#define MAX_SPI_SSEL 7
/* stop controller and re-config current chip*/
-static int restore_state(struct driver_data *drv_data)
+static void restore_state(struct driver_data *drv_data)
{
struct chip_data *chip = drv_data->cur_chip;
- int ret = 0;
/* Clear status and disable clock */
write_STAT(drv_data, BIT_STAT_CLR);
@@ -239,13 +238,6 @@
bfin_spi_enable(drv_data);
cs_active(drv_data, chip);
-
- if (ret)
- dev_dbg(&drv_data->pdev->dev,
- ": request chip select number %d failed\n",
- chip->chip_select_num);
-
- return ret;
}
/* used to kick off transfer in rx mode */
@@ -978,10 +970,7 @@
/* Setup the SSP using the per chip configuration */
drv_data->cur_chip = spi_get_ctldata(drv_data->cur_msg->spi);
- if (restore_state(drv_data)) {
- spin_unlock_irqrestore(&drv_data->lock, flags);
- return;
- };
+ restore_state(drv_data);
list_del_init(&drv_data->cur_msg->queue);