[BNX2]: Use msleep().
bnx2.c (incorrectly) sets current->state directly to
TASK_UNINTERRUPTIBLE, without going through set_task_state(). However
all the code wants to do is an msleep so just make it do that instead...
Signed-off-by: Arjan van de Ven <arjan@linux.intel.com>
Acked-by: Michael Chan <mchan@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/bnx2.c b/drivers/net/bnx2.c
index 24e7f9a..0091860 100644
--- a/drivers/net/bnx2.c
+++ b/drivers/net/bnx2.c
@@ -3935,10 +3935,8 @@
REG_WR(bp, BNX2_PCICFG_MISC_CONFIG, val);
if ((CHIP_ID(bp) == CHIP_ID_5706_A0) ||
- (CHIP_ID(bp) == CHIP_ID_5706_A1)) {
- current->state = TASK_UNINTERRUPTIBLE;
- schedule_timeout(HZ / 50);
- }
+ (CHIP_ID(bp) == CHIP_ID_5706_A1))
+ msleep(20);
/* Reset takes approximate 30 usec */
for (i = 0; i < 10; i++) {