net: make vlan ndo_vlan_rx_[add/kill]_vid return error value
Let caller know the result of adding/removing vlan id to/from vlan
filter.
In some drivers I make those functions to just return 0. But in those
where there is able to see if hw setup went correctly, return value is
set appropriately.
Signed-off-by: Jiri Pirko <jpirko@redhat.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/ethernet/intel/e1000e/netdev.c b/drivers/net/ethernet/intel/e1000e/netdev.c
index 93ae0c2..90953b4 100644
--- a/drivers/net/ethernet/intel/e1000e/netdev.c
+++ b/drivers/net/ethernet/intel/e1000e/netdev.c
@@ -2522,7 +2522,7 @@
return work_done;
}
-static void e1000_vlan_rx_add_vid(struct net_device *netdev, u16 vid)
+static int e1000_vlan_rx_add_vid(struct net_device *netdev, u16 vid)
{
struct e1000_adapter *adapter = netdev_priv(netdev);
struct e1000_hw *hw = &adapter->hw;
@@ -2532,7 +2532,7 @@
if ((adapter->hw.mng_cookie.status &
E1000_MNG_DHCP_COOKIE_STATUS_VLAN) &&
(vid == adapter->mng_vlan_id))
- return;
+ return 0;
/* add VID to filter table */
if (adapter->flags & FLAG_HAS_HW_VLAN_FILTER) {
@@ -2543,9 +2543,11 @@
}
set_bit(vid, adapter->active_vlans);
+
+ return 0;
}
-static void e1000_vlan_rx_kill_vid(struct net_device *netdev, u16 vid)
+static int e1000_vlan_rx_kill_vid(struct net_device *netdev, u16 vid)
{
struct e1000_adapter *adapter = netdev_priv(netdev);
struct e1000_hw *hw = &adapter->hw;
@@ -2556,7 +2558,7 @@
(vid == adapter->mng_vlan_id)) {
/* release control to f/w */
e1000e_release_hw_control(adapter);
- return;
+ return 0;
}
/* remove VID from filter table */
@@ -2568,6 +2570,8 @@
}
clear_bit(vid, adapter->active_vlans);
+
+ return 0;
}
/**