ath5k: add Mesh Point support
This enables draft-802.11s Mesh Point operation. For that we need mesh
beaconing. Tested with AR5212/AR5213 PCI card against Zydas and b43 mesh
nodes.
Signed-off-by: Andrey Yurovsky <andrey@cozybit.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/drivers/net/wireless/ath5k/base.c b/drivers/net/wireless/ath5k/base.c
index b20a45a..8bc9b92 100644
--- a/drivers/net/wireless/ath5k/base.c
+++ b/drivers/net/wireless/ath5k/base.c
@@ -1432,7 +1432,8 @@
ret = ath5k_hw_get_tx_queueprops(ah, sc->bhalq, &qi);
if (ret)
return ret;
- if (sc->opmode == IEEE80211_IF_TYPE_AP) {
+ if (sc->opmode == IEEE80211_IF_TYPE_AP ||
+ sc->opmode == IEEE80211_IF_TYPE_MESH_POINT) {
/*
* Always burst out beacon and CAB traffic
* (aifs = cwmin = cwmax = 0)
@@ -2932,6 +2933,7 @@
if (sc->opmode != IEEE80211_IF_TYPE_STA)
rfilt |= AR5K_RX_FILTER_PROBEREQ;
if (sc->opmode != IEEE80211_IF_TYPE_AP &&
+ sc->opmode != IEEE80211_IF_TYPE_MESH_POINT &&
test_bit(ATH_STAT_PROMISC, sc->status))
rfilt |= AR5K_RX_FILTER_PROM;
if (sc->opmode == IEEE80211_IF_TYPE_STA ||
diff --git a/drivers/net/wireless/ath5k/hw.c b/drivers/net/wireless/ath5k/hw.c
index ad1a5b4..b335d33 100644
--- a/drivers/net/wireless/ath5k/hw.c
+++ b/drivers/net/wireless/ath5k/hw.c
@@ -2387,6 +2387,7 @@
break;
case IEEE80211_IF_TYPE_AP:
+ case IEEE80211_IF_TYPE_MESH_POINT:
pcu_reg |= AR5K_STA_ID1_AP | AR5K_STA_ID1_RTS_DEF_ANTENNA |
(ah->ah_version == AR5K_AR5210 ?
AR5K_STA_ID1_NO_PSPOLL : 0);