regulator: twl: add clk32kg to twl-regulator
In OMAP4 Blaze and Panda, 32KHz clock to WLAN is supplied from Phoenix
TWL6030. The 32KHz clock state (ON/OFF) is configured in
CLK32KG_CFG_[GRP, TRANS, STATE] register. This follows the same register
programming model as other regulators in TWL6030. So add CLK32KG as pseudo
regulator.
Signed-off-by: Balaji T K <balajitk@ti.com>
Acked-by: Mark Brown <broonie@opensource.wolfsonmicro.com>
Signed-off-by: Samuel Ortiz <sameo@linux.intel.com>
diff --git a/drivers/regulator/twl-regulator.c b/drivers/regulator/twl-regulator.c
index bd332cf..6a29285 100644
--- a/drivers/regulator/twl-regulator.c
+++ b/drivers/regulator/twl-regulator.c
@@ -475,6 +475,13 @@
.get_status = twlreg_get_status,
};
+static struct regulator_ops twl6030_fixed_resource = {
+ .enable = twlreg_enable,
+ .disable = twlreg_disable,
+ .is_enabled = twlreg_is_enabled,
+ .get_status = twlreg_get_status,
+};
+
/*----------------------------------------------------------------------*/
#define TWL4030_FIXED_LDO(label, offset, mVolts, num, turnon_delay, \
@@ -538,6 +545,20 @@
}, \
}
+#define TWL6030_FIXED_RESOURCE(label, offset, num, turnon_delay, remap_conf) { \
+ .base = offset, \
+ .id = num, \
+ .delay = turnon_delay, \
+ .remap = remap_conf, \
+ .desc = { \
+ .name = #label, \
+ .id = TWL6030_REG_##label, \
+ .ops = &twl6030_fixed_resource, \
+ .type = REGULATOR_VOLTAGE, \
+ .owner = THIS_MODULE, \
+ }, \
+ }
+
/*
* We list regulators here if systems need some level of
* software control over them after boot.
@@ -577,7 +598,8 @@
TWL6030_FIXED_LDO(VANA, 0x50, 2100, 15, 0, 0x21),
TWL6030_FIXED_LDO(VCXIO, 0x60, 1800, 16, 0, 0x21),
TWL6030_FIXED_LDO(VDAC, 0x64, 1800, 17, 0, 0x21),
- TWL6030_FIXED_LDO(VUSB, 0x70, 3300, 18, 0, 0x21)
+ TWL6030_FIXED_LDO(VUSB, 0x70, 3300, 18, 0, 0x21),
+ TWL6030_FIXED_RESOURCE(CLK32KG, 0x8C, 48, 0, 0x21),
};
static int __devinit twlreg_probe(struct platform_device *pdev)