[SCSI] libsas: sgpio write support
Add SFF-8485 v0.7 / SAS-1 smp-write-gpio register support to libsas.
Defer SAS-2 support unless/until it defines an sgpio interface.
Minimum implementation needed to get the lights blinking.
try_test_sas_gpio_gp_bit() provides a common method to parse the
incoming write data (raw bitstream), and the to_sas_gpio_gp_bit() helper
routine can be used as a basis for the set/clear operations for the
'read' implementation. Host implementations parse as many bits
(ODx.[012]) as are locally supported and report the number of registers
successfully written. If the submitted data overruns the internal
number of registers available report the write as a success with the
number of bytes remaining reported in ->resid_len.
Example (assuming an active backplane) set the "identify" pattern for
the first 21 devices:
smp_write_gpio --count=2 --data=92,49,24,92,24,92,49,24 -t 4 --index=1 /dev/bsg/sas_hostX
Signed-off-by: Dan Williams <dan.j.williams@intel.com>
Signed-off-by: James Bottomley <JBottomley@Parallels.com>
diff --git a/include/scsi/sas.h b/include/scsi/sas.h
index e9fd022..a3001ad 100644
--- a/include/scsi/sas.h
+++ b/include/scsi/sas.h
@@ -195,6 +195,14 @@
SAS_OREJ_RSVD_RETRY = 18,
};
+enum sas_gpio_reg_type {
+ SAS_GPIO_REG_CFG = 0,
+ SAS_GPIO_REG_RX = 1,
+ SAS_GPIO_REG_RX_GP = 2,
+ SAS_GPIO_REG_TX = 3,
+ SAS_GPIO_REG_TX_GP = 4,
+};
+
struct dev_to_host_fis {
u8 fis_type; /* 0x34 */
u8 flags;