clk: qcom: Allow clk_set_parent() to work on display clocks
Sometimes the display driver may want to change the parent PLL of
the display clocks (byte and pixel clocks) depending on the
use-case. Currently the parent is fixed by means of having a
frequency table with one entry that chooses a particular parent.
Remove this restriction and use the parent the clock is
configured for in the hardware during clk_set_rate(). This
requires consumers to rely on the default parent or to configure
the parent with clk_set_parent()/assigned-clock-parents on the
clocks before calling clk_set_rate().
Tested-by: Archit Taneja <architt@codeaurora.org>
Cc: Hai Li <hali@codeaurora.org>
Signed-off-by: Stephen Boyd <sboyd@codeaurora.org>
diff --git a/drivers/clk/qcom/mmcc-msm8974.c b/drivers/clk/qcom/mmcc-msm8974.c
index 0987bf4..197700e 100644
--- a/drivers/clk/qcom/mmcc-msm8974.c
+++ b/drivers/clk/qcom/mmcc-msm8974.c
@@ -522,17 +522,11 @@
},
};
-static struct freq_tbl pixel_freq_tbl[] = {
- { .src = P_DSI0PLL },
- { }
-};
-
static struct clk_rcg2 pclk0_clk_src = {
.cmd_rcgr = 0x2000,
.mnd_width = 8,
.hid_width = 5,
.parent_map = mmcc_xo_dsi_hdmi_edp_gpll0_map,
- .freq_tbl = pixel_freq_tbl,
.clkr.hw.init = &(struct clk_init_data){
.name = "pclk0_clk_src",
.parent_names = mmcc_xo_dsi_hdmi_edp_gpll0,
@@ -547,7 +541,6 @@
.mnd_width = 8,
.hid_width = 5,
.parent_map = mmcc_xo_dsi_hdmi_edp_gpll0_map,
- .freq_tbl = pixel_freq_tbl,
.clkr.hw.init = &(struct clk_init_data){
.name = "pclk1_clk_src",
.parent_names = mmcc_xo_dsi_hdmi_edp_gpll0,
@@ -785,7 +778,7 @@
.name = "byte0_clk_src",
.parent_names = mmcc_xo_dsibyte_hdmi_edp_gpll0,
.num_parents = 6,
- .ops = &clk_byte_ops,
+ .ops = &clk_byte2_ops,
.flags = CLK_SET_RATE_PARENT,
},
};
@@ -799,7 +792,7 @@
.name = "byte1_clk_src",
.parent_names = mmcc_xo_dsibyte_hdmi_edp_gpll0,
.num_parents = 6,
- .ops = &clk_byte_ops,
+ .ops = &clk_byte2_ops,
.flags = CLK_SET_RATE_PARENT,
},
};