mmc: sh_mobile_sdhi: only change the clock on RCar Gen2+
We had a regression on r8a7740 where the SDHI clock was a generic
peripheral clock, so changing its rate was not desired. This should be
fixed in the clock driver. However, it also shows that the new clock
calculation should only be used on tested systems. Add a check for that.
Signed-off-by: Wolfram Sang <wsa+renesas@sang-engineering.com>
Tested-by: Geert Uytterhoeven <geert+renesas@glider.be>
Signed-off-by: Ulf Hansson <ulf.hansson@linaro.org>
diff --git a/drivers/mmc/host/sh_mobile_sdhi.c b/drivers/mmc/host/sh_mobile_sdhi.c
index 19e4c29..ac9ba36 100644
--- a/drivers/mmc/host/sh_mobile_sdhi.c
+++ b/drivers/mmc/host/sh_mobile_sdhi.c
@@ -168,6 +168,10 @@
unsigned int freq, diff, best_freq = 0, diff_min = ~0;
int i;
+ /* tested only on RCar Gen2+ currently; may work for others */
+ if (!(host->pdata->flags & TMIO_MMC_MIN_RCAR2))
+ return clk_get_rate(priv->clk);
+
/*
* We want the bus clock to be as close as possible to, but no
* greater than, new_clock. As we can divide by 1 << i for