IPoIB/cm: Fix timeout check in ipoib_cm_dev_stop()
time_after() was used backwards, so the timeout occurred immediately.
Signed-off-by: Michael S. Tsirkin <mst@dev.mellanox.co.il>
Signed-off-by: Roland Dreier <rolandd@cisco.com>
diff --git a/drivers/infiniband/ulp/ipoib/ipoib_cm.c b/drivers/infiniband/ulp/ipoib/ipoib_cm.c
index ffec794..e8fcd62 100644
--- a/drivers/infiniband/ulp/ipoib/ipoib_cm.c
+++ b/drivers/infiniband/ulp/ipoib/ipoib_cm.c
@@ -713,7 +713,7 @@
while (!list_empty(&priv->cm.rx_error_list) ||
!list_empty(&priv->cm.rx_flush_list) ||
!list_empty(&priv->cm.rx_drain_list)) {
- if (!time_after(jiffies, begin + 5 * HZ)) {
+ if (time_after(jiffies, begin + 5 * HZ)) {
ipoib_warn(priv, "RX drain timing out\n");
/*