open80211s: Stop using zero for address 3 in mesh plink mgmt frames
Previous versions of 11s draft used the all zeroes address. Current
draft uses the same address as address 2.
Also, use the ANA-approved action category code for peer establishment frames.
Note: This breaks compatibility with previous mesh protocol instances.
Signed-off-by: Javier Cardona <javier@cozybit.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/net/mac80211/mesh_plink.c b/net/mac80211/mesh_plink.c
index 0120e9e..2c37bee 100644
--- a/net/mac80211/mesh_plink.c
+++ b/net/mac80211/mesh_plink.c
@@ -43,7 +43,7 @@
#define dot11MeshMaxPeerLinks(s) (s->u.mesh.mshcfg.dot11MeshMaxPeerLinks)
enum plink_frame_type {
- PLINK_OPEN = 0,
+ PLINK_OPEN = 1,
PLINK_CONFIRM,
PLINK_CLOSE
};
@@ -181,7 +181,7 @@
IEEE80211_STYPE_ACTION);
memcpy(mgmt->da, da, ETH_ALEN);
memcpy(mgmt->sa, sdata->vif.addr, ETH_ALEN);
- /* BSSID is left zeroed, wildcard value */
+ memcpy(mgmt->bssid, sdata->vif.addr, ETH_ALEN);
mgmt->u.action.category = WLAN_CATEGORY_MESH_ACTION;
mgmt->u.action.u.plink_action.action_code = action;