drivers: net: irda: bfin_sir: fix compile error
Bit IREN is replaced by UMOD_IRDA and UMOD_MASK since blackfin 60x added, but
this driver didn't update which will cause bfin_sir build error:
drivers/net/irda/bfin_sir.c:161:9: error: 'IREN' undeclared (first use in this
function)
drivers/net/irda/bfin_sir.c:435:18: error: 'IREN' undeclared (first use in
this function)
drivers/net/irda/bfin_sir.c:521:11: error: 'IREN' undeclared (first use in
this function)
This patch fix it.
Signed-off-by: Sonic Zhang <sonic.zhang@analog.com>
Signed-off-by: Bob Liu <lliubbo@gmail.com>
Acked-by: Samuel Ortiz <samuel@sortiz.org>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/irda/bfin_sir.c b/drivers/net/irda/bfin_sir.c
index a561ae4..c6a0299 100644
--- a/drivers/net/irda/bfin_sir.c
+++ b/drivers/net/irda/bfin_sir.c
@@ -158,7 +158,7 @@
/* If not add the 'RPOLC', we can't catch the receive interrupt.
* It's related with the HW layout and the IR transiver.
*/
- val |= IREN | RPOLC;
+ val |= UMOD_IRDA | RPOLC;
UART_PUT_GCTL(port, val);
return ret;
}
@@ -432,7 +432,7 @@
bfin_sir_stop_rx(port);
val = UART_GET_GCTL(port);
- val &= ~(UCEN | IREN | RPOLC);
+ val &= ~(UCEN | UMOD_MASK | RPOLC);
UART_PUT_GCTL(port, val);
#ifdef CONFIG_SIR_BFIN_DMA
@@ -518,10 +518,10 @@
* reset all the UART.
*/
val = UART_GET_GCTL(port);
- val &= ~(IREN | RPOLC);
+ val &= ~(UMOD_MASK | RPOLC);
UART_PUT_GCTL(port, val);
SSYNC();
- val |= IREN | RPOLC;
+ val |= UMOD_IRDA | RPOLC;
UART_PUT_GCTL(port, val);
SSYNC();
/* bfin_sir_set_speed(port, self->speed); */