[SCSI] lpfc 8.3.21: FC Discovery changes
FC Discovery changes
- Treat received PLOGI while logged in as a relogin (unregister and reregister).
- Added a timer to delay Nport discovery when clean bit is cleared and Fabric
portname/nodename/FCID is changed.
- Invalidate Port's DID when receiving PLOGI from p2p port with CONFIG_PORT
mailbox command.
Signed-off-by: Alex Iannicelli <alex.iannicelli@emulex.com>
Signed-off-by: James Smart <james.smart@emulex.com>
Signed-off-by: James Bottomley <James.Bottomley@suse.de>
diff --git a/drivers/scsi/lpfc/lpfc_attr.c b/drivers/scsi/lpfc/lpfc_attr.c
index 745774c..a57f6c0 100644
--- a/drivers/scsi/lpfc/lpfc_attr.c
+++ b/drivers/scsi/lpfc/lpfc_attr.c
@@ -1,7 +1,7 @@
/*******************************************************************
* This file is part of the Emulex Linux Device Driver for *
* Fibre Channel Host Bus Adapters. *
- * Copyright (C) 2004-2009 Emulex. All rights reserved. *
+ * Copyright (C) 2004-2011 Emulex. All rights reserved. *
* EMULEX and SLI are trademarks of Emulex. *
* www.emulex.com *
* Portions Copyright (C) 2004-2005 Christoph Hellwig *
@@ -3365,6 +3365,25 @@
module_param(lpfc_prot_guard, byte, 0);
MODULE_PARM_DESC(lpfc_prot_guard, "host protection guard type");
+/*
+ * Delay initial NPort discovery when Clean Address bit is cleared in
+ * FLOGI/FDISC accept and FCID/Fabric name/Fabric portname is changed.
+ * This parameter can have value 0 or 1.
+ * When this parameter is set to 0, no delay is added to the initial
+ * discovery.
+ * When this parameter is set to non-zero value, initial Nport discovery is
+ * delayed by ra_tov seconds when Clean Address bit is cleared in FLOGI/FDISC
+ * accept and FCID/Fabric name/Fabric portname is changed.
+ * Driver always delay Nport discovery for subsequent FLOGI/FDISC completion
+ * when Clean Address bit is cleared in FLOGI/FDISC
+ * accept and FCID/Fabric name/Fabric portname is changed.
+ * Default value is 0.
+ */
+int lpfc_delay_discovery;
+module_param(lpfc_delay_discovery, int, 0);
+MODULE_PARM_DESC(lpfc_delay_discovery,
+ "Delay NPort discovery when Clean Address bit is cleared. "
+ "Allowed values: 0,1.");
/*
* lpfc_sg_seg_cnt - Initial Maximum DMA Segment Count