TTY: switch tty_insert_flip_char
Now, we start converting tty buffer functions to actually use
tty_port. This will allow us to get rid of the need of tty in many
call sites. Only tty_port will needed and hence no more
tty_port_tty_get in those paths.
tty_insert_flip_char is the next one to proceed. This one is used all
over the code, so the patch is huge.
Signed-off-by: Jiri Slaby <jslaby@suse.cz>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
diff --git a/drivers/tty/serial/nwpserial.c b/drivers/tty/serial/nwpserial.c
index dd4c31d..10d64a3 100644
--- a/drivers/tty/serial/nwpserial.c
+++ b/drivers/tty/serial/nwpserial.c
@@ -128,7 +128,8 @@
static irqreturn_t nwpserial_interrupt(int irq, void *dev_id)
{
struct nwpserial_port *up = dev_id;
- struct tty_struct *tty = up->port.state->port.tty;
+ struct tty_port *port = &up->port.state->port;
+ struct tty_struct *tty = port->tty;
irqreturn_t ret;
unsigned int iir;
unsigned char ch;
@@ -146,7 +147,7 @@
up->port.icount.rx++;
ch = dcr_read(up->dcr_host, UART_RX);
if (up->port.ignore_status_mask != NWPSERIAL_STATUS_RXVALID)
- tty_insert_flip_char(tty, ch, TTY_NORMAL);
+ tty_insert_flip_char(port, ch, TTY_NORMAL);
} while (dcr_read(up->dcr_host, UART_LSR) & UART_LSR_DR);
tty_flip_buffer_push(tty);