ASoC: z2: Automatically disconnect non-connected pins
Most DAPM input and output pins of the wm8750 are either used in the card's
DAPM routing table or are marked as not connected. The only exceptions are
the LINPUT1, RINPUT1, LINPUT2 input pins. Lets assume that those were
simply overlooked and that the routing table is complete.
Set the fully_routed flag of the card instead of manually marking the
unused inputs and outputs as not connected. This makes the code a bit
shorter and cleaner.
Signed-off-by: Lars-Peter Clausen <lars@metafoo.de>
Signed-off-by: Mark Brown <broonie@kernel.org>
diff --git a/sound/soc/pxa/z2.c b/sound/soc/pxa/z2.c
index bcbfbe8..990b1aa 100644
--- a/sound/soc/pxa/z2.c
+++ b/sound/soc/pxa/z2.c
@@ -132,16 +132,8 @@
*/
static int z2_wm8750_init(struct snd_soc_pcm_runtime *rtd)
{
- struct snd_soc_codec *codec = rtd->codec;
- struct snd_soc_dapm_context *dapm = &codec->dapm;
int ret;
- /* NC codec pins */
- snd_soc_dapm_disable_pin(dapm, "LINPUT3");
- snd_soc_dapm_disable_pin(dapm, "RINPUT3");
- snd_soc_dapm_disable_pin(dapm, "OUT3");
- snd_soc_dapm_disable_pin(dapm, "MONO1");
-
/* Jack detection API stuff */
ret = snd_soc_card_jack_new(rtd->card, "Headset Jack", SND_JACK_HEADSET,
&hs_jack, hs_jack_pins,
@@ -189,6 +181,7 @@
.num_dapm_widgets = ARRAY_SIZE(wm8750_dapm_widgets),
.dapm_routes = z2_audio_map,
.num_dapm_routes = ARRAY_SIZE(z2_audio_map),
+ .fully_routed = true,
};
static struct platform_device *z2_snd_device;