iwlwifi: configure transport layer from dvm op mode
Introduce the iwl_trans_config struct which contains
state variables that only the op mode can determine,
but which the transport layer needs to know.
Signed-off-by: Meenakshi Venkataraman <meenakshi.venkataraman@intel.com>
Signed-off-by: Wey-Yi Guy <wey-yi.w.guy@intel.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/drivers/net/wireless/iwlwifi/iwl-agn.c b/drivers/net/wireless/iwlwifi/iwl-agn.c
index 6ed2f78..83018ec 100644
--- a/drivers/net/wireless/iwlwifi/iwl-agn.c
+++ b/drivers/net/wireless/iwlwifi/iwl-agn.c
@@ -1185,6 +1185,7 @@
struct iwl_op_mode *op_mode;
u16 num_mac;
u32 ucode_flags;
+ struct iwl_trans_config trans_cfg;
/************************
* 1. Allocating HW data
@@ -1205,7 +1206,14 @@
/* TODO: remove fw from shared data later */
priv->shrd->fw = fw;
- iwl_trans_configure(trans(priv), op_mode);
+ /*
+ * Populate the state variables that the transport layer needs
+ * to know about.
+ */
+ trans_cfg.op_mode = op_mode;
+
+ /* Configure transport layer */
+ iwl_trans_configure(trans(priv), &trans_cfg);
/* At this point both hw and priv are allocated. */