ath9k: Revamp PCIE workarounds
* Disable L1 state ONLY when device is in D3 mode.
* Clear bit 22 of register 0x4004.
* Handle power on/off properly
Not setting the workarounds properly resulted in the
disappearance of the card in certain cases.
Signed-off-by: Vivek Natarajan <vnatarajan@atheros.com>
Signed-off-by: Sujith <Sujith.Manoharan@atheros.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/drivers/net/wireless/ath/ath9k/main.c b/drivers/net/wireless/ath/ath9k/main.c
index 3dc7b5a..5055f18 100644
--- a/drivers/net/wireless/ath/ath9k/main.c
+++ b/drivers/net/wireless/ath/ath9k/main.c
@@ -1131,7 +1131,7 @@
int r;
ath9k_ps_wakeup(sc);
- ath9k_hw_configpcipowersave(ah, 0);
+ ath9k_hw_configpcipowersave(ah, 0, 0);
if (!ah->curchan)
ah->curchan = ath_get_curchannel(sc, sc->hw);
@@ -1202,7 +1202,7 @@
spin_unlock_bh(&sc->sc_resetlock);
ath9k_hw_phy_disable(ah);
- ath9k_hw_configpcipowersave(ah, 1);
+ ath9k_hw_configpcipowersave(ah, 1, 1);
ath9k_ps_restore(sc);
ath9k_hw_setpower(ah, ATH9K_PM_FULL_SLEEP);
}
@@ -1942,7 +1942,7 @@
init_channel = ath_get_curchannel(sc, hw);
/* Reset SERDES registers */
- ath9k_hw_configpcipowersave(sc->sc_ah, 0);
+ ath9k_hw_configpcipowersave(sc->sc_ah, 0, 0);
/*
* The basic interface to setting the hardware in a good
@@ -2170,7 +2170,7 @@
/* disable HAL and put h/w to sleep */
ath9k_hw_disable(sc->sc_ah);
- ath9k_hw_configpcipowersave(sc->sc_ah, 1);
+ ath9k_hw_configpcipowersave(sc->sc_ah, 1, 1);
ath9k_hw_setpower(sc->sc_ah, ATH9K_PM_FULL_SLEEP);
sc->sc_flags |= SC_OP_INVALID;