myri*: Move the Myricom drivers
Move the Myricom drivers into drivers/net/ethernet/myricom/ and make
the necessary Kconfig and Makefile changes.
CC: Andrew Gallatin <gallatin@myri.com>
CC: Brice Goglin <brice@myri.com>
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>
diff --git a/drivers/net/ethernet/myricom/Kconfig b/drivers/net/ethernet/myricom/Kconfig
new file mode 100644
index 0000000..1816ae1
--- /dev/null
+++ b/drivers/net/ethernet/myricom/Kconfig
@@ -0,0 +1,46 @@
+#
+# Myricom device configuration
+#
+
+config NET_VENDOR_MYRI
+ bool "Myricom devices"
+ depends on PCI && INET
+ ---help---
+ If you have a network (Ethernet) card belonging to this class, say
+ Y and read the Ethernet-HOWTO, available from
+ <http://www.tldp.org/docs.html#howto>.
+
+ Note that the answer to this question doesn't directly affect the
+ kernel: saying N will just cause the configurator to skip all
+ the questions about Myricom cards. If you say Y, you will be asked for
+ your specific card in the following questions.
+
+if NET_VENDOR_MYRI
+
+config MYRI10GE
+ tristate "Myricom Myri-10G Ethernet support"
+ depends on PCI && INET
+ select FW_LOADER
+ select CRC32
+ select INET_LRO
+ ---help---
+ This driver supports Myricom Myri-10G Dual Protocol interface in
+ Ethernet mode. If the eeprom on your board is not recent enough,
+ you will need a newer firmware image.
+ You may get this image or more information, at:
+
+ <http://www.myri.com/scs/download-Myri10GE.html>
+
+ To compile this driver as a module, choose M here. The module
+ will be called myri10ge.
+
+config MYRI10GE_DCA
+ bool "Direct Cache Access (DCA) Support"
+ default y
+ depends on MYRI10GE && DCA && !(MYRI10GE=y && DCA=m)
+ ---help---
+ Say Y here if you want to use Direct Cache Access (DCA) in the
+ driver. DCA is a method for warming the CPU cache before data
+ is used, with the intent of lessening the impact of cache misses.
+
+endif # NET_VENDOR_MYRI