serial: 8250_pci: add Pericom PCIe Serial board Support (12d8:7952/4/8) - Chip PI7C9X7952/4/8
Signed-off-by: Angelo Butti <buttiangelo@gmail.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
diff --git a/drivers/tty/serial/8250/8250_pci.c b/drivers/tty/serial/8250/8250_pci.c
index 4ea45c15..4697a51 100644
--- a/drivers/tty/serial/8250/8250_pci.c
+++ b/drivers/tty/serial/8250/8250_pci.c
@@ -1307,6 +1307,29 @@
return setup_port(priv, port, bar, offset, board->reg_shift);
}
+static int pci_pericom_setup(struct serial_private *priv,
+ const struct pciserial_board *board,
+ struct uart_8250_port *port, int idx)
+{
+ unsigned int bar, offset = board->first_offset, maxnr;
+
+ bar = FL_GET_BASE(board->flags);
+ if (board->flags & FL_BASE_BARS)
+ bar += idx;
+ else
+ offset += idx * board->uart_offset;
+
+ maxnr = (pci_resource_len(priv->dev, bar) - board->first_offset) >>
+ (board->reg_shift + 3);
+
+ if (board->flags & FL_REGION_SZ_CAP && idx >= maxnr)
+ return 1;
+
+ port->port.uartclk = 14745600;
+
+ return setup_port(priv, port, bar, offset, board->reg_shift);
+}
+
static int
ce4100_serial_setup(struct serial_private *priv,
const struct pciserial_board *board,
@@ -2016,6 +2039,31 @@
.exit = pci_plx9050_exit,
},
/*
+ * Pericom
+ */
+ {
+ .vendor = 0x12d8,
+ .device = 0x7952,
+ .subvendor = PCI_ANY_ID,
+ .subdevice = PCI_ANY_ID,
+ .setup = pci_pericom_setup,
+ },
+ {
+ .vendor = 0x12d8,
+ .device = 0x7954,
+ .subvendor = PCI_ANY_ID,
+ .subdevice = PCI_ANY_ID,
+ .setup = pci_pericom_setup,
+ },
+ {
+ .vendor = 0x12d8,
+ .device = 0x7958,
+ .subvendor = PCI_ANY_ID,
+ .subdevice = PCI_ANY_ID,
+ .setup = pci_pericom_setup,
+ },
+
+ /*
* PLX
*/
{