| /* |
| * linux/mm/fremap.c |
| * |
| * Explicit pagetable population and nonlinear (random) mappings support. |
| * |
| * started by Ingo Molnar, Copyright (C) 2002, 2003 |
| */ |
| #include <linux/backing-dev.h> |
| #include <linux/mm.h> |
| #include <linux/swap.h> |
| #include <linux/file.h> |
| #include <linux/mman.h> |
| #include <linux/pagemap.h> |
| #include <linux/swapops.h> |
| #include <linux/rmap.h> |
| #include <linux/syscalls.h> |
| #include <linux/mmu_notifier.h> |
| |
| #include <asm/mmu_context.h> |
| #include <asm/cacheflush.h> |
| #include <asm/tlbflush.h> |
| |
| #include "internal.h" |
| |
| static void zap_pte(struct mm_struct *mm, struct vm_area_struct *vma, |
| unsigned long addr, pte_t *ptep) |
| { |
| pte_t pte = *ptep; |
| |
| if (pte_present(pte)) { |
| struct page *page; |
| |
| flush_cache_page(vma, addr, pte_pfn(pte)); |
| pte = ptep_clear_flush(vma, addr, ptep); |
| page = vm_normal_page(vma, addr, pte); |
| if (page) { |
| if (pte_dirty(pte)) |
| set_page_dirty(page); |
| page_remove_rmap(page); |
| page_cache_release(page); |
| update_hiwater_rss(mm); |
| dec_mm_counter(mm, MM_FILEPAGES); |
| } |
| } else { |
| if (!pte_file(pte)) |
| free_swap_and_cache(pte_to_swp_entry(pte)); |
| pte_clear_not_present_full(mm, addr, ptep, 0); |
| } |
| } |
| |
| /* |
| * Install a file pte to a given virtual memory address, release any |
| * previously existing mapping. |
| */ |
| static int install_file_pte(struct mm_struct *mm, struct vm_area_struct *vma, |
| unsigned long addr, unsigned long pgoff, pgprot_t prot) |
| { |
| int err = -ENOMEM; |
| pte_t *pte; |
| spinlock_t *ptl; |
| |
| pte = get_locked_pte(mm, addr, &ptl); |
| if (!pte) |
| goto out; |
| |
| if (!pte_none(*pte)) |
| zap_pte(mm, vma, addr, pte); |
| |
| set_pte_at(mm, addr, pte, pgoff_to_pte(pgoff)); |
| /* |
| * We don't need to run update_mmu_cache() here because the "file pte" |
| * being installed by install_file_pte() is not a real pte - it's a |
| * non-present entry (like a swap entry), noting what file offset should |
| * be mapped there when there's a fault (in a non-linear vma where |
| * that's not obvious). |
| */ |
| pte_unmap_unlock(pte, ptl); |
| err = 0; |
| out: |
| return err; |
| } |
| |
| static int populate_range(struct mm_struct *mm, struct vm_area_struct *vma, |
| unsigned long addr, unsigned long size, pgoff_t pgoff) |
| { |
| int err; |
| |
| do { |
| err = install_file_pte(mm, vma, addr, pgoff, vma->vm_page_prot); |
| if (err) |
| return err; |
| |
| size -= PAGE_SIZE; |
| addr += PAGE_SIZE; |
| pgoff++; |
| } while (size); |
| |
| return 0; |
| |
| } |
| |
| /** |
| * sys_remap_file_pages - remap arbitrary pages of an existing VM_SHARED vma |
| * @start: start of the remapped virtual memory range |
| * @size: size of the remapped virtual memory range |
| * @prot: new protection bits of the range (see NOTE) |
| * @pgoff: to-be-mapped page of the backing store file |
| * @flags: 0 or MAP_NONBLOCKED - the later will cause no IO. |
| * |
| * sys_remap_file_pages remaps arbitrary pages of an existing VM_SHARED vma |
| * (shared backing store file). |
| * |
| * This syscall works purely via pagetables, so it's the most efficient |
| * way to map the same (large) file into a given virtual window. Unlike |
| * mmap()/mremap() it does not create any new vmas. The new mappings are |
| * also safe across swapout. |
| * |
| * NOTE: the @prot parameter right now is ignored (but must be zero), |
| * and the vma's default protection is used. Arbitrary protections |
| * might be implemented in the future. |
| */ |
| SYSCALL_DEFINE5(remap_file_pages, unsigned long, start, unsigned long, size, |
| unsigned long, prot, unsigned long, pgoff, unsigned long, flags) |
| { |
| struct mm_struct *mm = current->mm; |
| struct address_space *mapping; |
| struct vm_area_struct *vma; |
| int err = -EINVAL; |
| int has_write_lock = 0; |
| |
| if (prot) |
| return err; |
| /* |
| * Sanitize the syscall parameters: |
| */ |
| start = start & PAGE_MASK; |
| size = size & PAGE_MASK; |
| |
| /* Does the address range wrap, or is the span zero-sized? */ |
| if (start + size <= start) |
| return err; |
| |
| /* Does pgoff wrap? */ |
| if (pgoff + (size >> PAGE_SHIFT) < pgoff) |
| return err; |
| |
| /* Can we represent this offset inside this architecture's pte's? */ |
| #if PTE_FILE_MAX_BITS < BITS_PER_LONG |
| if (pgoff + (size >> PAGE_SHIFT) >= (1UL << PTE_FILE_MAX_BITS)) |
| return err; |
| #endif |
| |
| /* We need down_write() to change vma->vm_flags. */ |
| down_read(&mm->mmap_sem); |
| retry: |
| vma = find_vma(mm, start); |
| |
| /* |
| * Make sure the vma is shared, that it supports prefaulting, |
| * and that the remapped range is valid and fully within |
| * the single existing vma. vm_private_data is used as a |
| * swapout cursor in a VM_NONLINEAR vma. |
| */ |
| if (!vma || !(vma->vm_flags & VM_SHARED)) |
| goto out; |
| |
| if (vma->vm_private_data && !(vma->vm_flags & VM_NONLINEAR)) |
| goto out; |
| |
| if (!(vma->vm_flags & VM_CAN_NONLINEAR)) |
| goto out; |
| |
| if (start < vma->vm_start || start + size > vma->vm_end) |
| goto out; |
| |
| /* Must set VM_NONLINEAR before any pages are populated. */ |
| if (!(vma->vm_flags & VM_NONLINEAR)) { |
| /* Don't need a nonlinear mapping, exit success */ |
| if (pgoff == linear_page_index(vma, start)) { |
| err = 0; |
| goto out; |
| } |
| |
| if (!has_write_lock) { |
| up_read(&mm->mmap_sem); |
| down_write(&mm->mmap_sem); |
| has_write_lock = 1; |
| goto retry; |
| } |
| mapping = vma->vm_file->f_mapping; |
| /* |
| * page_mkclean doesn't work on nonlinear vmas, so if |
| * dirty pages need to be accounted, emulate with linear |
| * vmas. |
| */ |
| if (mapping_cap_account_dirty(mapping)) { |
| unsigned long addr; |
| struct file *file = vma->vm_file; |
| |
| flags &= MAP_NONBLOCK; |
| get_file(file); |
| addr = mmap_region(file, start, size, |
| flags, vma->vm_flags, pgoff); |
| fput(file); |
| if (IS_ERR_VALUE(addr)) { |
| err = addr; |
| } else { |
| BUG_ON(addr != start); |
| err = 0; |
| } |
| goto out; |
| } |
| mutex_lock(&mapping->i_mmap_mutex); |
| flush_dcache_mmap_lock(mapping); |
| vma->vm_flags |= VM_NONLINEAR; |
| vma_prio_tree_remove(vma, &mapping->i_mmap); |
| vma_nonlinear_insert(vma, &mapping->i_mmap_nonlinear); |
| flush_dcache_mmap_unlock(mapping); |
| mutex_unlock(&mapping->i_mmap_mutex); |
| } |
| |
| if (vma->vm_flags & VM_LOCKED) { |
| /* |
| * drop PG_Mlocked flag for over-mapped range |
| */ |
| vm_flags_t saved_flags = vma->vm_flags; |
| munlock_vma_pages_range(vma, start, start + size); |
| vma->vm_flags = saved_flags; |
| } |
| |
| mmu_notifier_invalidate_range_start(mm, start, start + size); |
| err = populate_range(mm, vma, start, size, pgoff); |
| mmu_notifier_invalidate_range_end(mm, start, start + size); |
| if (!err && !(flags & MAP_NONBLOCK)) { |
| if (vma->vm_flags & VM_LOCKED) { |
| /* |
| * might be mapping previously unmapped range of file |
| */ |
| mlock_vma_pages_range(vma, start, start + size); |
| } else { |
| if (unlikely(has_write_lock)) { |
| downgrade_write(&mm->mmap_sem); |
| has_write_lock = 0; |
| } |
| make_pages_present(start, start+size); |
| } |
| } |
| |
| /* |
| * We can't clear VM_NONLINEAR because we'd have to do |
| * it after ->populate completes, and that would prevent |
| * downgrading the lock. (Locks can't be upgraded). |
| */ |
| |
| out: |
| if (likely(!has_write_lock)) |
| up_read(&mm->mmap_sem); |
| else |
| up_write(&mm->mmap_sem); |
| |
| return err; |
| } |