pinctrl: move CONFIG_PINCTRL to drivers/Makefile
Kbuild should descend into drivers/pinctrl/ only when CONFIG_PINCTRL
is enabled because everything under that directory depends on
CONFIG_PINCTRL.
We can avoid the conditional, ifeq ($(CONFIG_OF),y) ... endif.
Signed-off-by: Masahiro Yamada <yamada.masahiro@socionext.com>
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
diff --git a/drivers/Makefile b/drivers/Makefile
index b64b49f..e4b260e 100644
--- a/drivers/Makefile
+++ b/drivers/Makefile
@@ -11,7 +11,7 @@
obj-$(CONFIG_GENERIC_PHY) += phy/
# GPIO must come after pinctrl as gpios may need to mux pins etc
-obj-y += pinctrl/
+obj-$(CONFIG_PINCTRL) += pinctrl/
obj-y += gpio/
obj-y += pwm/
obj-$(CONFIG_PCI) += pci/
diff --git a/drivers/pinctrl/Makefile b/drivers/pinctrl/Makefile
index f6710a8..76ba976 100644
--- a/drivers/pinctrl/Makefile
+++ b/drivers/pinctrl/Makefile
@@ -2,12 +2,10 @@
subdir-ccflags-$(CONFIG_DEBUG_PINCTRL) += -DDEBUG
-obj-$(CONFIG_PINCTRL) += core.o pinctrl-utils.o
+obj-y += core.o pinctrl-utils.o
obj-$(CONFIG_PINMUX) += pinmux.o
obj-$(CONFIG_PINCONF) += pinconf.o
-ifeq ($(CONFIG_OF),y)
-obj-$(CONFIG_PINCTRL) += devicetree.o
-endif
+obj-$(CONFIG_OF) += devicetree.o
obj-$(CONFIG_GENERIC_PINCONF) += pinconf-generic.o
obj-$(CONFIG_PINCTRL_ADI2) += pinctrl-adi2.o
obj-$(CONFIG_PINCTRL_AS3722) += pinctrl-as3722.o