usb: dwc2: Use platform endianness when accessing registers
This patch switches calls to readl/writel to their
dwc2_readl/dwc2_writel equivalents which preserve platform endianness.
This patch is necessary to access dwc2 registers correctly on big-endian
systems such as the mips based SoCs made by Lantiq. Then dwc2 can be
used to replace ifx-hcd driver for Lantiq platforms found e.g. in
OpenWrt.
The patch was autogenerated with the following commands:
$EDITOR core.h
sed -i "s/\<readl\>/dwc2_readl/g" *.c hcd.h hw.h
sed -i "s/\<writel\>/dwc2_writel/g" *.c hcd.h hw.h
Some files were then hand-edited to fix checkpatch.pl warnings about
too long lines.
Signed-off-by: Antti Seppälä <a.seppala@gmail.com>
Signed-off-by: Vincent Pelletier <plr.vincent@gmail.com>
Signed-off-by: John Youn <johnyoun@synopsys.com>
Signed-off-by: Felipe Balbi <balbi@ti.com>
diff --git a/drivers/usb/dwc2/hcd_queue.c b/drivers/usb/dwc2/hcd_queue.c
index 3ad63d3..712977f 100644
--- a/drivers/usb/dwc2/hcd_queue.c
+++ b/drivers/usb/dwc2/hcd_queue.c
@@ -115,7 +115,7 @@
if (qh->ep_type == USB_ENDPOINT_XFER_INT)
qh->interval = 8;
#endif
- hprt = readl(hsotg->regs + HPRT0);
+ hprt = dwc2_readl(hsotg->regs + HPRT0);
prtspd = (hprt & HPRT0_SPD_MASK) >> HPRT0_SPD_SHIFT;
if (prtspd == HPRT0_SPD_HIGH_SPEED &&
(dev_speed == USB_SPEED_LOW ||
@@ -595,9 +595,9 @@
if (status)
return status;
if (!hsotg->periodic_qh_count) {
- intr_mask = readl(hsotg->regs + GINTMSK);
+ intr_mask = dwc2_readl(hsotg->regs + GINTMSK);
intr_mask |= GINTSTS_SOF;
- writel(intr_mask, hsotg->regs + GINTMSK);
+ dwc2_writel(intr_mask, hsotg->regs + GINTMSK);
}
hsotg->periodic_qh_count++;
@@ -632,9 +632,9 @@
dwc2_deschedule_periodic(hsotg, qh);
hsotg->periodic_qh_count--;
if (!hsotg->periodic_qh_count) {
- intr_mask = readl(hsotg->regs + GINTMSK);
+ intr_mask = dwc2_readl(hsotg->regs + GINTMSK);
intr_mask &= ~GINTSTS_SOF;
- writel(intr_mask, hsotg->regs + GINTMSK);
+ dwc2_writel(intr_mask, hsotg->regs + GINTMSK);
}
}