sdhci: make sure to clear the error interrupt
The controller has a bit indicating that one of the higher bits (the
error bits) are set. A previous bug caused this bit to be masked, but
since that bug has been fixed we have to clear it explicictly.
Signed-off-by: Pierre Ossman <drzeus@drzeus.cx>
diff --git a/drivers/mmc/host/sdhci.c b/drivers/mmc/host/sdhci.c
index 10d15c3..4a24db02 100644
--- a/drivers/mmc/host/sdhci.c
+++ b/drivers/mmc/host/sdhci.c
@@ -1024,6 +1024,8 @@
intmask &= ~(SDHCI_INT_CMD_MASK | SDHCI_INT_DATA_MASK);
+ intmask &= ~SDHCI_INT_ERROR;
+
if (intmask & SDHCI_INT_BUS_POWER) {
printk(KERN_ERR "%s: Card is consuming too much power!\n",
mmc_hostname(host->mmc));
diff --git a/drivers/mmc/host/sdhci.h b/drivers/mmc/host/sdhci.h
index 7400f4b..a6c8704 100644
--- a/drivers/mmc/host/sdhci.h
+++ b/drivers/mmc/host/sdhci.h
@@ -107,6 +107,7 @@
#define SDHCI_INT_CARD_INSERT 0x00000040
#define SDHCI_INT_CARD_REMOVE 0x00000080
#define SDHCI_INT_CARD_INT 0x00000100
+#define SDHCI_INT_ERROR 0x00008000
#define SDHCI_INT_TIMEOUT 0x00010000
#define SDHCI_INT_CRC 0x00020000
#define SDHCI_INT_END_BIT 0x00040000