gianfar: Fix RXICr/TXICr programming for multi-queue mode
The correct behavior is to program the interrupt coalescing regs
(RXICr/TXICr) in accordance with the Rx/Tx Q's "rx/txcoalescing"
flag. That is, if the coalescing flag is 0 for a given Rx/Tx queue
then the corresponding coalescing register should be cleared.
This behavior is correctly implemented for the single-queue mode
(SQ_SG_MODE), but not for the multi-queue mode (MQ_MG_MODE).
This fixes the later case.
Signed-off-by: Claudiu Manoil <claudiu.manoil@freescale.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/ethernet/freescale/gianfar.c b/drivers/net/ethernet/freescale/gianfar.c
index 0741ade..f2db8fc 100644
--- a/drivers/net/ethernet/freescale/gianfar.c
+++ b/drivers/net/ethernet/freescale/gianfar.c
@@ -1804,18 +1804,16 @@
if (priv->mode == MQ_MG_MODE) {
baddr = ®s->txic0;
for_each_set_bit(i, &tx_mask, priv->num_tx_queues) {
- if (likely(priv->tx_queue[i]->txcoalescing)) {
- gfar_write(baddr + i, 0);
+ gfar_write(baddr + i, 0);
+ if (likely(priv->tx_queue[i]->txcoalescing))
gfar_write(baddr + i, priv->tx_queue[i]->txic);
- }
}
baddr = ®s->rxic0;
for_each_set_bit(i, &rx_mask, priv->num_rx_queues) {
- if (likely(priv->rx_queue[i]->rxcoalescing)) {
- gfar_write(baddr + i, 0);
+ gfar_write(baddr + i, 0);
+ if (likely(priv->rx_queue[i]->rxcoalescing))
gfar_write(baddr + i, priv->rx_queue[i]->rxic);
- }
}
}
}