Documentation: dt: update TI GPMC ethernet binding properties

The GPMC timing properties for device-tree have been updated
by adding a "-ns" or "-ps" suffix to indicate the units of
time the property represents. Therefore, update the timing
property names for TI GPMC ethernet binding.

Signed-off-by: Javier Martinez Canillas <javier.martinez@collabora.co.uk>
Signed-off-by: Jon Hunter <jon-hunter@ti.com>
diff --git a/Documentation/devicetree/bindings/net/gpmc-eth.txt b/Documentation/devicetree/bindings/net/gpmc-eth.txt
index 24cb4e4..ace4a64 100644
--- a/Documentation/devicetree/bindings/net/gpmc-eth.txt
+++ b/Documentation/devicetree/bindings/net/gpmc-eth.txt
@@ -26,16 +26,16 @@
 - bank-width: 		Address width of the device in bytes. GPMC supports 8-bit
 			and 16-bit devices and so must be either 1 or 2 bytes.
 - compatible:		Compatible string property for the ethernet child device.
-- gpmc,cs-on:		Chip-select assertion time
-- gpmc,cs-rd-off:	Chip-select de-assertion time for reads
-- gpmc,cs-wr-off:	Chip-select de-assertion time for writes
-- gpmc,oe-on:		Output-enable assertion time
-- gpmc,oe-off		Output-enable de-assertion time
-- gpmc,we-on:		Write-enable assertion time
-- gpmc,we-off:		Write-enable de-assertion time
-- gpmc,access:		Start cycle to first data capture (read access)
-- gpmc,rd-cycle:	Total read cycle time
-- gpmc,wr-cycle:	Total write cycle time
+- gpmc,cs-on-ns:	Chip-select assertion time
+- gpmc,cs-rd-off-ns:	Chip-select de-assertion time for reads
+- gpmc,cs-wr-off-ns:	Chip-select de-assertion time for writes
+- gpmc,oe-on-ns:	Output-enable assertion time
+- gpmc,oe-off-ns:	Output-enable de-assertion time
+- gpmc,we-on-ns:	Write-enable assertion time
+- gpmc,we-off-ns:	Write-enable de-assertion time
+- gpmc,access-ns:	Start cycle to first data capture (read access)
+- gpmc,rd-cycle-ns:	Total read cycle time
+- gpmc,wr-cycle-ns:	Total write cycle time
 - reg:			Chip-select, base address (relative to chip-select)
 			and size of the memory mapped for the device.
 			Note that base address will be typically 0 as this
@@ -65,24 +65,24 @@
 		bank-width = <2>;
 
 		gpmc,mux-add-data;
-		gpmc,cs-on = <0>;
-		gpmc,cs-rd-off = <186>;
-		gpmc,cs-wr-off = <186>;
-		gpmc,adv-on = <12>;
-		gpmc,adv-rd-off = <48>;
-		gpmc,adv-wr-off = <48>;
-		gpmc,oe-on = <54>;
-		gpmc,oe-off = <168>;
-		gpmc,we-on = <54>;
-		gpmc,we-off = <168>;
-		gpmc,rd-cycle = <186>;
-		gpmc,wr-cycle = <186>;
-		gpmc,access = <114>;
-		gpmc,page-burst-access = <6>;
-		gpmc,bus-turnaround = <12>;
-		gpmc,cycle2cycle-delay = <18>;
-		gpmc,wr-data-mux-bus = <90>;
-		gpmc,wr-access = <186>;
+		gpmc,cs-on-ns = <0>;
+		gpmc,cs-rd-off-ns = <186>;
+		gpmc,cs-wr-off-ns = <186>;
+		gpmc,adv-on-ns = <12>;
+		gpmc,adv-rd-off-ns = <48>;
+		gpmc,adv-wr-off-ns = <48>;
+		gpmc,oe-on-ns = <54>;
+		gpmc,oe-off-ns = <168>;
+		gpmc,we-on-ns = <54>;
+		gpmc,we-off-ns = <168>;
+		gpmc,rd-cycle-ns = <186>;
+		gpmc,wr-cycle-ns = <186>;
+		gpmc,access-ns = <114>;
+		gpmc,page-burst-access-ns = <6>;
+		gpmc,bus-turnaround-ns = <12>;
+		gpmc,cycle2cycle-delay-ns = <18>;
+		gpmc,wr-data-mux-bus-ns = <90>;
+		gpmc,wr-access-ns = <186>;
 		gpmc,cycle2cycle-samecsen;
 		gpmc,cycle2cycle-diffcsen;