[MIPS] Define MIPS_CPU_IRQ_BASE in generic header
The irq_base for {mips,rm7k,rm9k}_cpu_irq_init() are constant on all
platforms and are same value on most platforms (0 or 16, depends on
CONFIG_I8259). Define them in asm-mips/mach-generic/irq.h and make
them customizable. This will save a few cycle on each CPU interrupt.
A good side effect is removing some dependencies to MALTA in generic
SMTC code.
Although MIPS_CPU_IRQ_BASE is customizable, this patch changes irq
mappings on DDB5477, EMMA2RH and MIPS_SIM, since really customizing
them might cause some header dependency problem and there seems no
good reason to customize it. So currently only VR41XX is using custom
MIPS_CPU_IRQ_BASE value, which is 0 regardless of CONFIG_I8259.
Testing this patch on those platforms is greatly appreciated. Thank
you.
Signed-off-by: Atsushi Nemoto <anemo@mba.ocn.ne.jp>
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>
diff --git a/arch/mips/emma2rh/markeins/irq.c b/arch/mips/emma2rh/markeins/irq.c
index c93369c..3299b6d 100644
--- a/arch/mips/emma2rh/markeins/irq.c
+++ b/arch/mips/emma2rh/markeins/irq.c
@@ -106,7 +106,7 @@
emma2rh_irq_init(EMMA2RH_IRQ_BASE);
emma2rh_sw_irq_init(EMMA2RH_SW_IRQ_BASE);
emma2rh_gpio_irq_init(EMMA2RH_GPIO_IRQ_BASE);
- mips_cpu_irq_init(CPU_IRQ_BASE);
+ mips_cpu_irq_init();
/* setup cascade interrupts */
setup_irq(EMMA2RH_IRQ_BASE + EMMA2RH_SW_CASCADE, &irq_cascade);