OMAP4: DPLL: Add dpll api to control GATE_CTRL
On OMAP4, the dpll post divider outputs (MX outputs)
along with clockout_x2 output provide a way to allow/deny
hardware level autogating.
Allowing autoidle would mean that the hw would autogate
this clock when there is no dependency for it.
Denying idle would mean that this clock output will be
forced to stay enabled.
Add dpll api's to read/allow/deny idle control
for these dpll mx postdividers.
NOTE: The gatectrl bit set to 0 allows gatectrl,
and the bit set to 1 denies gatectrl.
Signed-off-by: Rajendra Nayak <rnayak@ti.com>
[paul@pwsan.com: moved OMAP4-specific DPLL control code to
mach-omap2/dpll44xx.c; added some documentation for CLOCK_CLKOUTX2]
Signed-off-by: Paul Walmsley <paul@pwsan.com>
diff --git a/arch/arm/mach-omap2/clock.h b/arch/arm/mach-omap2/clock.h
index 2a939e5..c450d69 100644
--- a/arch/arm/mach-omap2/clock.h
+++ b/arch/arm/mach-omap2/clock.h
@@ -65,6 +65,9 @@
int omap3_noncore_dpll_set_rate(struct clk *clk, unsigned long rate);
int omap3_noncore_dpll_enable(struct clk *clk);
void omap3_noncore_dpll_disable(struct clk *clk);
+int omap4_dpllmx_gatectrl_read(struct clk *clk);
+void omap4_dpllmx_allow_gatectrl(struct clk *clk);
+void omap4_dpllmx_deny_gatectrl(struct clk *clk);
#ifdef CONFIG_OMAP_RESET_CLOCKS
void omap2_clk_disable_unused(struct clk *clk);