pinctrl: qcom-spmi-gpio: Fix output type configuration
GPIO output type configuration was incorrectly overwritten
by strength value. Fix this.
Signed-off-by: Ivan T. Ivanov <ivan.ivanov@linaro.org>
Acked-by: Bjorn Andersson <bjorn.andersson@sonymobile.com>
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
diff --git a/drivers/pinctrl/qcom/pinctrl-spmi-gpio.c b/drivers/pinctrl/qcom/pinctrl-spmi-gpio.c
index b2d2221..4b21aac 100644
--- a/drivers/pinctrl/qcom/pinctrl-spmi-gpio.c
+++ b/drivers/pinctrl/qcom/pinctrl-spmi-gpio.c
@@ -417,7 +417,7 @@
return ret;
val = pad->buffer_type << PMIC_GPIO_REG_OUT_TYPE_SHIFT;
- val = pad->strength << PMIC_GPIO_REG_OUT_STRENGTH_SHIFT;
+ val |= pad->strength << PMIC_GPIO_REG_OUT_STRENGTH_SHIFT;
ret = pmic_gpio_write(state, pad, PMIC_GPIO_REG_DIG_OUT_CTL, val);
if (ret < 0)