[SCSI] isci: change sas phy timeouts from 54us to 59us
Need the following workaround in the driver for interoperability with
the older Intel SSD drives and any other SATA drive that may exhibit the
same behavior. This is a corner case where SCU speed is limited to
either 3G or 1.5G and the drive has a period of DC idle when it switches
speed during SATA speed negotiation. Workaround :change PHYTOV[31:24]
from 0x36 to 0x3B.
Signed-off-by: Marcin Tomczak <marcin.tomczak@intel.com>
Signed-off-by: Dan Williams <dan.j.williams@intel.com>
Signed-off-by: James Bottomley <JBottomley@Parallels.com>
diff --git a/drivers/scsi/isci/registers.h b/drivers/scsi/isci/registers.h
index 9b266c7..00afc73 100644
--- a/drivers/scsi/isci/registers.h
+++ b/drivers/scsi/isci/registers.h
@@ -1299,6 +1299,18 @@
#define SCU_AFE_XCVRCR_OFFSET 0x00DC
#define SCU_AFE_LUTCR_OFFSET 0x00E0
+#define SCU_SAS_PHY_TIMER_TIMEOUT_VALUES_ALIGN_DETECTION_SHIFT (0UL)
+#define SCU_SAS_PHY_TIMER_TIMEOUT_VALUES_ALIGN_DETECTION_MASK (0x000000FFUL)
+#define SCU_SAS_PHY_TIMER_TIMEOUT_VALUES_HOT_PLUG_SHIFT (8UL)
+#define SCU_SAS_PHY_TIMER_TIMEOUT_VALUES_HOT_PLUG_MASK (0x0000FF00UL)
+#define SCU_SAS_PHY_TIMER_TIMEOUT_VALUES_COMSAS_DETECTION_SHIFT (16UL)
+#define SCU_SAS_PHY_TIMER_TIMEOUT_VALUES_COMSAS_DETECTION_MASK (0x00FF0000UL)
+#define SCU_SAS_PHY_TIMER_TIMEOUT_VALUES_RATE_CHANGE_SHIFT (24UL)
+#define SCU_SAS_PHY_TIMER_TIMEOUT_VALUES_RATE_CHANGE_MASK (0xFF000000UL)
+
+#define SCU_SAS_PHYTOV_GEN_VAL(name, value) \
+ SCU_GEN_VALUE(SCU_SAS_PHY_TIMER_TIMEOUT_VALUES_##name, value)
+
#define SCU_SAS_LINK_LAYER_CONTROL_MAX_LINK_RATE_SHIFT (0)
#define SCU_SAS_LINK_LAYER_CONTROL_MAX_LINK_RATE_MASK (0x00000003)
#define SCU_SAS_LINK_LAYER_CONTROL_MAX_LINK_RATE_GEN1 (0)