[PATCH] ahci: preserve PORTS_IMPL over host resets
Instead of writing 0xf blindly, preserve the content of write-once
PORTS_IMPL register over host resets.
This patch is taken from Jeff Garzik's AHCI init update patch.
Signed-off-by: Tejun Heo <htejun@gmail.com>
Signed-off-by: Jeff Garzik <jeff@garzik.org>
diff --git a/drivers/ata/ahci.c b/drivers/ata/ahci.c
index bc6599e..f2277be 100644
--- a/drivers/ata/ahci.c
+++ b/drivers/ata/ahci.c
@@ -421,6 +421,11 @@
};
+static inline int ahci_nr_ports(u32 cap)
+{
+ return (cap & 0x1f) + 1;
+}
+
static inline unsigned long ahci_port_base_ul (unsigned long base, unsigned int port)
{
return base + 0x100 + (port * 0x80);
@@ -630,11 +635,12 @@
static int ahci_reset_controller(void __iomem *mmio, struct pci_dev *pdev)
{
- u32 cap_save, tmp;
+ u32 cap_save, impl_save, tmp;
cap_save = readl(mmio + HOST_CAP);
cap_save &= ( (1<<28) | (1<<17) );
cap_save |= (1 << 27);
+ impl_save = readl(mmio + HOST_PORTS_IMPL);
/* global controller reset */
tmp = readl(mmio + HOST_CTL);
@@ -655,10 +661,21 @@
return -EIO;
}
+ /* turn on AHCI mode */
writel(HOST_AHCI_EN, mmio + HOST_CTL);
(void) readl(mmio + HOST_CTL); /* flush */
+
+ /* These write-once registers are normally cleared on reset.
+ * Restore BIOS values... which we HOPE were present before
+ * reset.
+ */
+ if (!impl_save) {
+ impl_save = (1 << ahci_nr_ports(cap_save)) - 1;
+ dev_printk(KERN_WARNING, &pdev->dev,
+ "PORTS_IMPL is zero, forcing 0x%x\n", impl_save);
+ }
writel(cap_save, mmio + HOST_CAP);
- writel(0xf, mmio + HOST_PORTS_IMPL);
+ writel(impl_save, mmio + HOST_PORTS_IMPL);
(void) readl(mmio + HOST_PORTS_IMPL); /* flush */
if (pdev->vendor == PCI_VENDOR_ID_INTEL) {
@@ -1467,7 +1484,7 @@
hpriv->cap = readl(mmio + HOST_CAP);
hpriv->port_map = readl(mmio + HOST_PORTS_IMPL);
- probe_ent->n_ports = (hpriv->cap & 0x1f) + 1;
+ probe_ent->n_ports = ahci_nr_ports(hpriv->cap);
VPRINTK("cap 0x%x port_map 0x%x n_ports %d\n",
hpriv->cap, hpriv->port_map, probe_ent->n_ports);