IB/ipath: Clean send flags properly on QP reset
Signed-off-by: Robert Walsh <robert.walsh@qlogic.com>
Signed-off-by: Ralph Campbell <ralph.campbell@qlogic.com>
Signed-off-by: Roland Dreier <rolandd@cisco.com>
diff --git a/drivers/infiniband/hw/ipath/ipath_qp.c b/drivers/infiniband/hw/ipath/ipath_qp.c
index 9e07abb..bfd39c9 100644
--- a/drivers/infiniband/hw/ipath/ipath_qp.c
+++ b/drivers/infiniband/hw/ipath/ipath_qp.c
@@ -336,7 +336,7 @@
qp->qkey = 0;
qp->qp_access_flags = 0;
qp->s_busy = 0;
- qp->s_flags &= ~IPATH_S_SIGNAL_REQ_WR;
+ qp->s_flags &= IPATH_S_SIGNAL_REQ_WR;
qp->s_hdrwords = 0;
qp->s_psn = 0;
qp->r_psn = 0;