mmc: mmc: extend the mmc_send_tuning()
The mmc_execute_tuning() has already prepared the opcode,
there is no need to prepare it again at mmc_send_tuning(),
and, there is a BUG of mmc_send_tuning() to determine the opcode
by bus width, assume eMMC was running at HS200, 4bit mode,
then the mmc_send_tuning() will overwrite the opcode from CMD21
to CMD19, then got error.
in addition, extend an argument of "cmd_error" to allow getting
if there was cmd error when tune response.
Signed-off-by: Chaotian Jing <chaotian.jing@mediatek.com>
[Ulf: Rebased patch]
Signed-off-by: Ulf Hansson <ulf.hansson@linaro.org>
diff --git a/drivers/mmc/host/sdhci-sirf.c b/drivers/mmc/host/sdhci-sirf.c
index f5488c4..34866f6 100644
--- a/drivers/mmc/host/sdhci-sirf.c
+++ b/drivers/mmc/host/sdhci-sirf.c
@@ -98,7 +98,7 @@
clock_setting | phase,
SDHCI_CLK_DELAY_SETTING);
- if (!mmc_send_tuning(mmc)) {
+ if (!mmc_send_tuning(mmc, opcode, NULL)) {
/* Tuning is successful at this tuning point */
tuned_phase_cnt++;
dev_dbg(mmc_dev(mmc), "%s: Found good phase = %d\n",