bfin: delay IRQ registration until driver is ready
Make sure we do not actually request the RTC IRQ until the device driver
is fully ready to handle and process any interrupt. This way a spurious
interrupt won't crash the system (which may happen if the bootloader was
poking the RTC right before booting Linux).
Signed-off-by: Mike Frysinger <vapier@gentoo.org>
Signed-off-by: Alessandro Zummo <a.zummo@towertech.it>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
diff --git a/drivers/rtc/rtc-bfin.c b/drivers/rtc/rtc-bfin.c
index aafd3e6..a118eb0 100644
--- a/drivers/rtc/rtc-bfin.c
+++ b/drivers/rtc/rtc-bfin.c
@@ -1,8 +1,8 @@
/*
* Blackfin On-Chip Real Time Clock Driver
- * Supports BF52[257]/BF53[123]/BF53[467]/BF54[24789]
+ * Supports BF51x/BF52x/BF53[123]/BF53[467]/BF54x
*
- * Copyright 2004-2008 Analog Devices Inc.
+ * Copyright 2004-2009 Analog Devices Inc.
*
* Enter bugs at http://blackfin.uclinux.org/
*
@@ -363,7 +363,7 @@
struct bfin_rtc *rtc;
struct device *dev = &pdev->dev;
int ret = 0;
- unsigned long timeout;
+ unsigned long timeout = jiffies + HZ;
dev_dbg_stamp(dev);
@@ -374,32 +374,32 @@
platform_set_drvdata(pdev, rtc);
device_init_wakeup(dev, 1);
+ /* Register our RTC with the RTC framework */
+ rtc->rtc_dev = rtc_device_register(pdev->name, dev, &bfin_rtc_ops,
+ THIS_MODULE);
+ if (unlikely(IS_ERR(rtc->rtc_dev))) {
+ ret = PTR_ERR(rtc->rtc_dev);
+ goto err;
+ }
+
/* Grab the IRQ and init the hardware */
ret = request_irq(IRQ_RTC, bfin_rtc_interrupt, IRQF_SHARED, pdev->name, dev);
if (unlikely(ret))
- goto err;
+ goto err_reg;
/* sometimes the bootloader touched things, but the write complete was not
* enabled, so let's just do a quick timeout here since the IRQ will not fire ...
*/
- timeout = jiffies + HZ;
while (bfin_read_RTC_ISTAT() & RTC_ISTAT_WRITE_PENDING)
if (time_after(jiffies, timeout))
break;
bfin_rtc_reset(dev, RTC_ISTAT_WRITE_COMPLETE);
bfin_write_RTC_SWCNT(0);
- /* Register our RTC with the RTC framework */
- rtc->rtc_dev = rtc_device_register(pdev->name, dev, &bfin_rtc_ops, THIS_MODULE);
- if (unlikely(IS_ERR(rtc->rtc_dev))) {
- ret = PTR_ERR(rtc->rtc_dev);
- goto err_irq;
- }
-
return 0;
- err_irq:
- free_irq(IRQ_RTC, dev);
- err:
+err_reg:
+ rtc_device_unregister(rtc->rtc_dev);
+err:
kfree(rtc);
return ret;
}