wl12xx: AP-mode - fix race condition on sta connection
If a sta starts transmitting immediately after authentication, sometimes
the FW deauthenticates it. Fix this by marking the sta "in-connection"
in FW before sending the autentication response.
The "in-connection" entry is automatically removed when connection
succeeds or after a timeout.
Signed-off-by: Arik Nemtsov <arik@wizery.com>
Signed-off-by: Luciano Coelho <coelho@ti.com>
diff --git a/drivers/net/wireless/wl12xx/acx.c b/drivers/net/wireless/wl12xx/acx.c
index 6d53129..3badc6b 100644
--- a/drivers/net/wireless/wl12xx/acx.c
+++ b/drivers/net/wireless/wl12xx/acx.c
@@ -1541,3 +1541,28 @@
kfree(config_ps);
return ret;
}
+
+int wl1271_acx_set_inconnection_sta(struct wl1271 *wl, u8 *addr)
+{
+ struct wl1271_acx_inconnection_sta *acx = NULL;
+ int ret;
+
+ wl1271_debug(DEBUG_ACX, "acx set inconnaction sta %pM", addr);
+
+ acx = kzalloc(sizeof(*acx), GFP_KERNEL);
+ if (!acx)
+ return -ENOMEM;
+
+ memcpy(acx->addr, addr, ETH_ALEN);
+
+ ret = wl1271_cmd_configure(wl, ACX_UPDATE_INCONNECTION_STA_LIST,
+ acx, sizeof(*acx));
+ if (ret < 0) {
+ wl1271_warning("acx set inconnaction sta failed: %d", ret);
+ goto out;
+ }
+
+out:
+ kfree(acx);
+ return ret;
+}