davinci: move PLL wait time values to clock.h
As suspend support is added, the code supporting
the suspend operation needs to bypass PLLs and
needs to access the same wait time values as the
PLL code in clock.c.
To facilitate this, move the PLL wait times to
clock.h where they can be accessed by suspend code.
Signed-off-by: Sekhar Nori <nsekhar@ti.com>
Signed-off-by: Kevin Hilman <khilman@deeprootsystems.com>
diff --git a/arch/arm/mach-davinci/clock.c b/arch/arm/mach-davinci/clock.c
index baece65..0fa68c5 100644
--- a/arch/arm/mach-davinci/clock.c
+++ b/arch/arm/mach-davinci/clock.c
@@ -376,7 +376,7 @@
locktime = ((2000 * prediv) / 100);
prediv = (prediv - 1) | PLLDIV_EN;
} else {
- locktime = 20;
+ locktime = PLL_LOCK_TIME;
}
if (postdiv)
postdiv = (postdiv - 1) | PLLDIV_EN;
@@ -389,12 +389,7 @@
ctrl &= ~(PLLCTL_PLLENSRC | PLLCTL_PLLEN);
__raw_writel(ctrl, pll->base + PLLCTL);
- /*
- * Wait for 4 OSCIN/CLKIN cycles to ensure that the PLLC has switched
- * to bypass mode. Delay of 1us ensures we are good for all > 4MHz
- * OSCIN/CLKIN inputs. Typically the input is ~25MHz.
- */
- udelay(1);
+ udelay(PLL_BYPASS_TIME);
/* Reset and enable PLL */
ctrl &= ~(PLLCTL_PLLRST | PLLCTL_PLLDIS);
@@ -408,11 +403,7 @@
if (pll->flags & PLL_HAS_POSTDIV)
__raw_writel(postdiv, pll->base + POSTDIV);
- /*
- * Wait for PLL to reset properly, OMAP-L138 datasheet says
- * 'min' time = 125ns
- */
- udelay(1);
+ udelay(PLL_RESET_TIME);
/* Bring PLL out of reset */
ctrl |= PLLCTL_PLLRST;