ieee802154: add TX power control to wpan_phy
Replace the current u8 transmit_power in wpan_phy with s8 transmit_power.
The u8 field contained the actual tx power and a tolerance field,
which no physical radio every used. Adjust sysfs entries to keep
compatibility with userspace, give tolerances of +-1dB statically there.
This patch only adds support for this in the at86rf230 driver and the
RF212 chip. Configuration calculation for RF212 is also somewhat basic,
but does the job - the RF212 datasheet gives a large table with
suggested values for combinations of TX power and page/channel, if this
does not work well, we might have to copy the whole table.
Signed-off-by: Phoebe Buckheister <phoebe.buckheister@itwm.fraunhofer.de>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/ieee802154/at86rf230.c b/drivers/net/ieee802154/at86rf230.c
index bd1ef0b..9afb4b9d 100644
--- a/drivers/net/ieee802154/at86rf230.c
+++ b/drivers/net/ieee802154/at86rf230.c
@@ -753,6 +753,30 @@
return 0;
}
+static int
+at86rf212_set_txpower(struct ieee802154_dev *dev, int db)
+{
+ struct at86rf230_local *lp = dev->priv;
+ int rc;
+
+ /* typical maximum output is 5dBm with RG_PHY_TX_PWR 0x60, lower five
+ * bits decrease power in 1dB steps. 0x60 represents extra PA gain of
+ * 0dB.
+ * thus, supported values for db range from -26 to 5, for 31dB of
+ * reduction to 0dB of reduction.
+ */
+ if (db > 5 || db < -26)
+ return -EINVAL;
+
+ db = -(db - 5);
+
+ rc = __at86rf230_write(lp, RG_PHY_TX_PWR, 0x60 | db);
+ if (rc)
+ return rc;
+
+ return 0;
+}
+
static struct ieee802154_ops at86rf230_ops = {
.owner = THIS_MODULE,
.xmit = at86rf230_xmit,
@@ -771,6 +795,7 @@
.start = at86rf230_start,
.stop = at86rf230_stop,
.set_hw_addr_filt = at86rf230_set_hw_addr_filt,
+ .set_txpower = at86rf212_set_txpower,
};
static void at86rf230_irqwork(struct work_struct *work)