[netdrvr] use dev_xxx() printk helpers, rather than dev_printk(KERN_xxx, ...
Suggested by Jiri Slaby.
Signed-off-by: Jeff Garzik <jeff@garzik.org>
diff --git a/drivers/net/8139cp.c b/drivers/net/8139cp.c
index 93b7c90..d2150ba 100644
--- a/drivers/net/8139cp.c
+++ b/drivers/net/8139cp.c
@@ -1836,11 +1836,10 @@
if (pdev->vendor == PCI_VENDOR_ID_REALTEK &&
pdev->device == PCI_DEVICE_ID_REALTEK_8139 && pci_rev < 0x20) {
- dev_printk(KERN_ERR, &pdev->dev,
+ dev_err(&pdev->dev,
"This (id %04x:%04x rev %02x) is not an 8139C+ compatible chip\n",
pdev->vendor, pdev->device, pci_rev);
- dev_printk(KERN_ERR, &pdev->dev,
- "Try the \"8139too\" driver instead.\n");
+ dev_err(&pdev->dev, "Try the \"8139too\" driver instead.\n");
return -ENODEV;
}
@@ -1878,13 +1877,12 @@
pciaddr = pci_resource_start(pdev, 1);
if (!pciaddr) {
rc = -EIO;
- dev_printk(KERN_ERR, &pdev->dev, "no MMIO resource\n");
+ dev_err(&pdev->dev, "no MMIO resource\n");
goto err_out_res;
}
if (pci_resource_len(pdev, 1) < CP_REGS_SIZE) {
rc = -EIO;
- dev_printk(KERN_ERR, &pdev->dev,
- "MMIO resource (%llx) too small\n",
+ dev_err(&pdev->dev, "MMIO resource (%llx) too small\n",
(unsigned long long)pci_resource_len(pdev, 1));
goto err_out_res;
}
@@ -1899,13 +1897,13 @@
rc = pci_set_dma_mask(pdev, DMA_32BIT_MASK);
if (rc) {
- dev_printk(KERN_ERR, &pdev->dev,
+ dev_err(&pdev->dev,
"No usable DMA configuration, aborting.\n");
goto err_out_res;
}
rc = pci_set_consistent_dma_mask(pdev, DMA_32BIT_MASK);
if (rc) {
- dev_printk(KERN_ERR, &pdev->dev,
+ dev_err(&pdev->dev,
"No usable consistent DMA configuration, "
"aborting.\n");
goto err_out_res;
@@ -1918,8 +1916,7 @@
regs = ioremap(pciaddr, CP_REGS_SIZE);
if (!regs) {
rc = -EIO;
- dev_printk(KERN_ERR, &pdev->dev,
- "Cannot map PCI MMIO (%llx@%llx)\n",
+ dev_err(&pdev->dev, "Cannot map PCI MMIO (%lx@%lx)\n",
(unsigned long long)pci_resource_len(pdev, 1),
(unsigned long long)pciaddr);
goto err_out_res;