blob: 61f46affcf7a64a2648c781896901fc3b70c91c8 [file] [log] [blame]
#
# for USB OTG silicon based on Mentor Graphics INVENTRA designs
#
ccflags-$(CONFIG_USB_MUSB_DEBUG) := -DDEBUG
obj-$(CONFIG_USB_MUSB_HDRC) += musb_hdrc.o
musb_hdrc-y := musb_core.o
musb_hdrc-$(CONFIG_USB_GADGET_MUSB_HDRC) += musb_gadget_ep0.o musb_gadget.o
musb_hdrc-$(CONFIG_USB_MUSB_HDRC_HCD) += musb_virthub.o musb_host.o
musb_hdrc-$(CONFIG_DEBUG_FS) += musb_debugfs.o
# Hardware Glue Layer
obj-$(CONFIG_USB_MUSB_OMAP2PLUS) += omap2430.o
obj-$(CONFIG_USB_MUSB_AM35X) += am35x.o
obj-$(CONFIG_USB_MUSB_TUSB6010) += tusb6010.o
obj-$(CONFIG_USB_MUSB_DAVINCI) += davinci.o
obj-$(CONFIG_USB_MUSB_DA8XX) += da8xx.o
obj-$(CONFIG_USB_MUSB_BLACKFIN) += blackfin.o
# the kconfig must guarantee that only one of the
# possible I/O schemes will be enabled at a time ...
# PIO only, or DMA (several potential schemes).
# though PIO is always there to back up DMA, and for ep0
ifneq ($(CONFIG_MUSB_PIO_ONLY),y)
ifeq ($(CONFIG_USB_INVENTRA_DMA),y)
musb_hdrc-y += musbhsdma.o
else
ifeq ($(CONFIG_USB_TI_CPPI_DMA),y)
musb_hdrc-y += cppi_dma.o
else
ifeq ($(CONFIG_USB_TUSB_OMAP_DMA),y)
musb_hdrc-y += tusb6010_omap.o
endif
endif
endif
endif