leds: bcm6328: Reuse bcm6328_led_set() instead of copying its functionality
When ensuring a consistent initial LED state in bcm6328_led (as they may
be blinking instead of on/off), the LED register is set using an inverted
copy of bcm6328_led_set(). To avoid further errors relating to active low
handling, call this function directly instead.
As bcm6328_led_set() acquires the same spinlock again when updating the
register, it is called after unlocking.
Signed-off-by: Simon Arlott <simon@fire.lp0.eu>
Signed-off-by: Jacek Anaszewski <j.anaszewski@samsung.com>
diff --git a/drivers/leds/leds-bcm6328.c b/drivers/leds/leds-bcm6328.c
index c7ea5c6..95d0cf9 100644
--- a/drivers/leds/leds-bcm6328.c
+++ b/drivers/leds/leds-bcm6328.c
@@ -314,14 +314,10 @@
} else {
led->cdev.brightness = LED_OFF;
}
-
- if ((led->active_low && led->cdev.brightness == LED_FULL) ||
- (!led->active_low && led->cdev.brightness == LED_OFF))
- bcm6328_led_mode(led, BCM6328_LED_MODE_ON);
- else
- bcm6328_led_mode(led, BCM6328_LED_MODE_OFF);
spin_unlock_irqrestore(lock, flags);
+ bcm6328_led_set(&led->cdev, led->cdev.brightness);
+
led->cdev.brightness_set = bcm6328_led_set;
led->cdev.blink_set = bcm6328_blink_set;