x86, x2apic: enable fault handling for intr-remapping
Impact: interface augmentation (not yet used)
Enable fault handling flow for intr-remapping aswell. Fault handling
code now shared by both dma-remapping and intr-remapping.
Signed-off-by: Suresh Siddha <suresh.b.siddha@intel.com>
Signed-off-by: H. Peter Anvin <hpa@linux.intel.com>
diff --git a/arch/x86/kernel/apic/io_apic.c b/arch/x86/kernel/apic/io_apic.c
index 00e6071..b18a773 100644
--- a/arch/x86/kernel/apic/io_apic.c
+++ b/arch/x86/kernel/apic/io_apic.c
@@ -3294,7 +3294,12 @@
} else
#endif
{
- msg->address_hi = MSI_ADDR_BASE_HI;
+ if (x2apic_enabled())
+ msg->address_hi = MSI_ADDR_BASE_HI |
+ MSI_ADDR_EXT_DEST_ID(dest);
+ else
+ msg->address_hi = MSI_ADDR_BASE_HI;
+
msg->address_lo =
MSI_ADDR_BASE_LO |
((apic->irq_dest_mode == 0) ?
@@ -3528,7 +3533,7 @@
destroy_irq(irq);
}
-#ifdef CONFIG_DMAR
+#if defined (CONFIG_DMAR) || defined (CONFIG_INTR_REMAP)
#ifdef CONFIG_SMP
static void dmar_msi_set_affinity(unsigned int irq, const struct cpumask *mask)
{