x86, x2apic: enable fault handling for intr-remapping
Impact: interface augmentation (not yet used)
Enable fault handling flow for intr-remapping aswell. Fault handling
code now shared by both dma-remapping and intr-remapping.
Signed-off-by: Suresh Siddha <suresh.b.siddha@intel.com>
Signed-off-by: H. Peter Anvin <hpa@linux.intel.com>
diff --git a/include/linux/dmar.h b/include/linux/dmar.h
index f284407..c776833 100644
--- a/include/linux/dmar.h
+++ b/include/linux/dmar.h
@@ -49,6 +49,7 @@
/* Intel IOMMU detection */
extern void detect_intel_iommu(void);
+extern int enable_drhd_fault_handling(void);
extern int parse_ioapics_under_ir(void);
@@ -116,9 +117,6 @@
#define intr_remapping_enabled (0)
#endif
-#ifdef CONFIG_DMAR
-extern const char *dmar_get_fault_reason(u8 fault_reason);
-
/* Can't use the common MSI interrupt functions
* since DMAR is not a pci device
*/
@@ -129,6 +127,7 @@
extern int dmar_set_interrupt(struct intel_iommu *iommu);
extern int arch_setup_dmar_msi(unsigned int irq);
+#ifdef CONFIG_DMAR
extern int iommu_detected, no_iommu;
extern struct list_head dmar_rmrr_units;
struct dmar_rmrr_unit {