icnss: Delay Shutdown/reinit sequence for all cases
PD down notifications reaches APPS only after WLAN HW is
reset. Because of this, there is a small window of time
in which APPS may try to access WLAN HW Copy Engine
registers and get into exception. To avoid this, FW has
implemented 2 stage reset sequence in which first HW is
halted rather than reset and then when FW PD is started
again, reset sequence is executed. Because of the 2
stage reset sequence, WLAN shutdown call back also needs
to be delayed as there may be some buffers submitted to
hardware and if they are freed then again HW exception
may be seen. Delay the shutdown call back till FW ready
happens at this time HW should be reset and clean state.
CRs-fixed: 2056443
Change-Id: Ie587f98d574f7c0a49a8480449fed44c1f4ab816
Signed-off-by: Anurag Chouhan <achouhan@codeaurora.org>
1 file changed