usb: musb: dsps: do not set is_active on the first drvbus interrupt
Quite early on init there is an vbus / drvvbus interrupt comming and the
dsps code sets is_active to one. As a result we see a lot of
|musb_bus_suspend 2459: trying to suspend as a_wait_bcon while active
until a device is plugged in with pm_runtime enabled in the kernel.
After checking davinci, am35, da8xx I noticed that dsps is actually the
only one doing this.
So remove it and we won't flooded with mesages and the idle port can be
suspended.
Signed-off-by: Sebastian Andrzej Siewior <bigeasy@linutronix.de>
Signed-off-by: Felipe Balbi <balbi@ti.com>
diff --git a/drivers/usb/musb/musb_dsps.c b/drivers/usb/musb/musb_dsps.c
index 4ead0f5..392406d 100644
--- a/drivers/usb/musb/musb_dsps.c
+++ b/drivers/usb/musb/musb_dsps.c
@@ -314,7 +314,6 @@
jiffies + wrp->poll_seconds * HZ);
WARNING("VBUS error workaround (delay coming)\n");
} else if (drvvbus) {
- musb->is_active = 1;
MUSB_HST_MODE(musb);
musb->xceiv->otg->default_a = 1;
musb->xceiv->state = OTG_STATE_A_WAIT_VRISE;