epic100: Test __BIG_ENDIAN instead of (non-existent) CONFIG_BIG_ENDIAN
Probably no one has used this driver on big-endian systems, since it was
setting up descriptor swapping if CONFIG_BIG_ENDIAN is set, which it
never is, since that symbol is not mentioned anywhere else in the kernel
source. Switch this test to a check for __BIG_ENDIAN so it has a chance
at working.
Signed-off-by: Roland Dreier <rolandd@cisco.com>
Acked-by: Jeff Garzik <jgarzik@redhat.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/epic100.c b/drivers/net/epic100.c
index 6838dfc..4c27465 100644
--- a/drivers/net/epic100.c
+++ b/drivers/net/epic100.c
@@ -87,6 +87,7 @@
#include <linux/bitops.h>
#include <asm/io.h>
#include <asm/uaccess.h>
+#include <asm/byteorder.h>
/* These identify the driver base version and may not be removed. */
static char version[] __devinitdata =
@@ -230,7 +231,7 @@
* The EPIC100 Rx and Tx buffer descriptors. Note that these
* really ARE host-endian; it's not a misannotation. We tell
* the card to byteswap them internally on big-endian hosts -
- * look for #ifdef CONFIG_BIG_ENDIAN in epic_open().
+ * look for #ifdef __BIG_ENDIAN in epic_open().
*/
struct epic_tx_desc {
@@ -690,7 +691,7 @@
outl((inl(ioaddr + NVCTL) & ~0x003C) | 0x4800, ioaddr + NVCTL);
/* Tell the chip to byteswap descriptors on big-endian hosts */
-#ifdef CONFIG_BIG_ENDIAN
+#ifdef __BIG_ENDIAN
outl(0x4432 | (RX_FIFO_THRESH<<8), ioaddr + GENCTL);
inl(ioaddr + GENCTL);
outl(0x0432 | (RX_FIFO_THRESH<<8), ioaddr + GENCTL);
@@ -806,7 +807,7 @@
for (i = 16; i > 0; i--)
outl(0x0008, ioaddr + TEST1);
-#ifdef CONFIG_BIG_ENDIAN
+#ifdef __BIG_ENDIAN
outl(0x0432 | (RX_FIFO_THRESH<<8), ioaddr + GENCTL);
#else
outl(0x0412 | (RX_FIFO_THRESH<<8), ioaddr + GENCTL);